Simultaneous On-State Voltage and Bond-Wire Resistance Monitoring of Silicon Carbide MOSFETs
نویسندگان
چکیده
In fast switching power semiconductors, the use of a fourth terminal to provide the reference potential for the gate signal—known as a kelvin-source terminal—is becoming common. The introduction of this terminal presents opportunities for condition monitoring systems. This article demonstrates how the voltage between the kelvin-source and power-source can be used to specifically monitor bond-wire degradation. Meanwhile, the drain to kelvin-source voltage can be monitored to track defects in the semiconductor die or gate driver. Through an accelerated aging test on 20 A Silicon Carbide Metal-Oxide-Semiconductor-Field-Effect Transistors (MOSFETs), it is shown that there are opposing trends in the evolution of the on-state resistances of both the bond-wires and the MOSFET die. In summary, after 50,000 temperature cycles, the resistance of the bond-wires increased by up to 2 mΩ, while the on-state resistance of the MOSFET dies decreased by approximately 1 mΩ. The conventional failure precursor (monitoring a single forward voltage) cannot distinguish between semiconductor die or bond-wire degradation. Therefore, the ability to monitor both these parameters due to the presence of an auxiliary-source terminal can provide more detailed information regarding the aging process of a device.
منابع مشابه
Analysis of Voltage Variation in Silicon Carbide MOSFETs during Turn-On and Turn-Off
Due to our limited knowledge about silicon carbide metal–oxide–semiconductor fieldeffect transistors (SiC MOSFETs), the theoretical analysis and change regularity in terms of the effects of temperature on their switching characteristics have not been fully characterized and understood. An analysis of variation in voltage (dVDS/dt) for SiC MOSFET during turn-on and turn-off has been performed th...
متن کاملThreshold voltage instabilities of present SiC-power MOSFETs under positive bias temperature stress
We study the threshold voltage (Vth) instability of commercially available silicon carbide (SiC) power MOSFETs or prototypes from four different manufacturers under positive bias temperature stress (PBTS). A positive bias near Vth causes a threshold voltage shift of 0.7 mV per decade in time per nanometer oxide thickness in the temperature range between -50°C and 150°C. Recovery at +5 V after a...
متن کاملA New Approach to High Efficincy in Isolated Boost Converters for High-Power Low- Voltage Fuel Cell Apllications
A new low-leakage-inductance low-resistance design approach to low-voltage high-power isolated boost converters is presented. Very low levels of parasitic circuit inductances are achieved by optimizing transformer design and circuit lay-out. Primary side voltage clamp circuits can be eliminated by the use of power MOSFETs fully rated for repetitive avalanche. Voltage rating of primary switches ...
متن کاملA Comprehensive Study on the Avalanche Breakdown Robustness of Silicon Carbide Power MOSFETs
This paper presents an in-depth investigation into the avalanche breakdown robustness of commercial state-of-the-art silicon carbide (SiC) power MOSFETs comprising of functional as well as structural characterization and the corresponding underlying physical mechanisms responsible for device failure. One aspect of robustness for power MOSFETs is determined by its ability to withstand energy dur...
متن کاملCree Silicon Carbide Power White Paper: Highly Efficient, and Compact ZVS Resonant Full Bridge Converter Using 1200V SiC MOSFETs
Rev. Abstract The most recent version (C2MTM) of Silicon Carbide (SiC) devices is used in a Zero Voltage Switching (ZVS) converter application. A 1200V, 160mohm SiC MOSFET from Cree Inc. is used to design a high-frequency ZVS LLC resonant fullbridge (FB) DC/DC converter. With the outstanding advantages of SiC MOSFET, which has lower junction capacitance and low-on-state resistor compared to a s...
متن کامل