Expert System for Sintering Process Control based on the Information about solid-fuel Flow Composition
ثبت نشده
چکیده
Usually, the solid-fuel flow of an iron ore sinter plant consists of different types of the solid-fuels, which differ from each other. Information about the composition of the solid-fuel flow usually comes every 8-24 hours. It can be clearly seen that this information cannot be used to control the sintering process in real time. Due to this, we propose an expert system which uses indirect measurements from the process in order to obtain the composition of the solid-fuel flow by solving an optimization task. Then this information can be used to control the sintering process. The proposed technique can be successfully used to improve sinter quality and reduce the amount of solid-fuel used by the process. Keywords—sintering process, particle swarm optimization, optimal control, expert system, solid-fuel
منابع مشابه
Dynamic Response Analysis of the Planar and Tubular Solid Oxide Fuel Cells to the Inlet Air Mass Flow Rate Variation
The purpose of present study is to investigate the dynamic response of two conventional types of solid oxide fuel cells to the inlet air mass flow rate variation. A dynamic compartmental model based on CFD principles is developed for two typical planar and tubular SOFC designs. The model accounts for transport processes (heat and mass transfer), diffusion processes, electrochemical processes, a...
متن کاملEffect of Mechanical Alloying and Sintering on Phase Transformation, Microstructural Evolution, Mechanical Properties and Density of Zr-Cr Alloy
The purpose of present research was production ofZr-based alloy as the nuclear fuel cladding by mechanical alloying (MA) and sintering process. Firstly, Zr and Cr powders were mechanically alloyed to produce the refractory and hard Zr-10 wt% Cr alloy, and then, the powder mixtures were consolidated by press and following sintering at temperature of 800˚C min. The phase evolution, microstructura...
متن کاملExpert System for Sintering Process Control
Sintering is a method that makes powdered materials (such as fine ore or preparation concentrate) into block mass under conditions involving incomplete fusion by heating to high temperature. Its production is sinter which is irregular and porous (FU et al., 1996). The following parts are usually included in sintering process: acceptance and storage of iron-containing raw materials, fuel and flu...
متن کاملModeling and Analysis of a Solid Oxide Fuel Cell Based Trigeneration System with an Oxygenated Fuel by Using an Exergoeconomic Methodology for Power, Heating and Cooling Production
In the present study, thermo-economic analysis of a combined solid oxide fuel cell (SOFC) with a gas turbine, a generator-absorber heat exchanger (GAX) and heating process heat exchanger for heating, cooling and power production as a tri-generation system is conducted. Also, an external steam reformer is applied to convert methanol as oxygenated fuel to hydrogen for the electrochemical process ...
متن کاملHierachical intelligent optimization blending system based on production indices for lead-zinc sintering process
In lead-zinc sintering process, various kinds of lead-zinc concentrates and returning powder from ineligible sintering production are blended and then sintered in updraft sintering machine to produce agglomerate for imperial smelting process. It is required to determine a proper mixture ratio for these materials blended to assure sintering production indices such as agglomerate composition and ...
متن کامل