New Insight of Maximum Transferred Power by Matching Capacitance of a Wireless Power Transfer System
نویسندگان
چکیده
Most research on wireless power transfer (WPT) has been focused on how to achieve a high-efficiency power transfer. Our study found that under the impedance matching for achieving maximum WPT efficiency, the power transferred to the load cannot reach the maximum when a WPT system is supplied by an AC voltage source with constant amplitude. However, the load power or the voltage across the load is essential for a low-power electric device such as the implanted medical device where the transfer efficiency is not the priority to be considered. The paper presents a method for achieving maximum power on the load by matching capacitance in a WPT system with given two-coupled-coils. Three sets of matching capacitances for extreme load power were deduced based on the circuit model considering the coil's resistance, and all these three matching make the WPT system operate at the resonant state. Two sets can make the system achieve the global maximum of load power. One set can make the system achieve the local maximum of load power and reach the power transfer efficiency next to 1. Experimental results verified the theoretical calculations. The results can contribute to the compensation design of a practical WPT system for transferring the maximum power to the load.
منابع مشابه
High Efficient Wireless Charger for Electric Vehicle with Reduced Sensitivity to Misalignment using Multilevel Inverter
Wireless power transfer (WPT) has been found to be a practical replacement for cable power transfer which provides a wide range of applications. This technology offers a remarkable solution for charging electric vehicles (EVs) due to more convenience and increased safety. Moreover dynamic (in-motion) wireless charging offers the possibility of reducing the energy storage requirement on the veh...
متن کاملStabilizing the Operating Frequency of a Resonant Converter for Wireless Power Transfer to Implantable Biomedical Sensors
Resonant converters have been applied in wireless power supplies for implantable sensors due to their inherent advantages of low cost, high frequency and high reliability. However, the operating frequency of the resonant converter varies with the load and circuit parameters changes, which can significantly reduce the maximum power that the system can transfer. As a result the implanted sensors ...
متن کاملThroughput Maximization for Multi-Slot Data Transmission via Two-Hop DF SWIPT-Based UAV System
In this paper, an unmanned aerial vehicle (UAV) assisted cooperative communication system is studied, wherein a source transmits information to the destination through an energy harvesting decode-and-forward UAV. It is assumed that the UAV can freely move in between the source-destination pair to set up line of sight communications with the both nodes. Since the battery of the UAV may be limite...
متن کاملModeling, Simulation and Control of Matrix Convert for Variable Speed Wind Turbine System
This paper presents modeling, simulation and control of matrix converter (MC) for variable speed wind turbine (VSWT) system including permanent magnet synchronous generator (PMSG). At a given wind velocity, the power available from a wind turbine is a function of its shaft speed. In order to track maximum power, the MC adjusts the PMSG shaft speed.The proposed control system allowing independen...
متن کاملHYREP: A Hybrid Low-Power Protocol for Wireless Sensor Networks
In this paper, a new hybrid routing protocol is presented for low power Wireless Sensor Networks (WSNs). The new system uses an integrated piezoelectric energy harvester to increase the network lifetime. Power dissipation is one of the most important factors affecting lifetime of a WSN. An innovative cluster head selection technique using Cuckoo optimization algorithm has been used in the desig...
متن کامل