Crossover from Two- to Three-Dimensional Turbulence.
نویسندگان
چکیده
Forced rotating turbulence is simulated within a periodic box of small aspect ratio. Critical parameter values are found for the stability of a 2D inverse cascade of energy in the presence of 3D motions at small scales. There is a critical rotation rate below which 2D forcing leads to an equilibrated 3D state, while for a slightly larger rotation rate, 3D forcing drives a 2D inverse cascade. It is shown that inverse and forward cascades of energy can coexist. This study is relevant to geophysical flows, and contains physics beyond the scope of quasigeostrophic models. [S0031-9007(96)01175-1]
منابع مشابه
Experimental study and numerical simulation of three dimensional two phase impinging jet flow using anisotropic turbulence model
Hydrodynamic of a turbulent impinging jet on a flat plate has been studied experimentally and numerically. Experiments were conducted for the Reynolds number range of 72000 to 102000 and a fixed jet-to-plate dimensionless distance of H/d=3.5. Based on the experimental setup, a multi-phase numerical model was simulated to predict flow properties of impinging jets using two turbulent models. Mesh...
متن کاملNumerical Predictions of Turbulent Mixed Convection Heat Transfer to Supercritical Fluids Using Various Low Reynolds Number k-e Turbulence Models
There are a number of systems in which supercritical cryogenic fluids are used as coolants or propellant fluids. In some modern military aircraft, the fuel is pressurized above its critical point and used as a coolant to remove heat from the aircraft engine. Accurate prediction of heat transfer coefficients to turbulent flows of supercritical fluids is essential in design of such systems. One o...
متن کاملTHREE DIMENSIONAL MODELING OF TURBULENT FLOW WITH FREE SURFACE IN MOLD FILLING
In the present study a Finite Difference Method has been developed to model the transient incompressible turbulent free surface fluid flow. A single fluid has been selected for modeling of mold filling and The SOLA VOF 3D technique was modified to increase the accuracy of simulation of filling phenomena for shape castings. For modeling the turbulence phenomena k-e standard model was used. In or...
متن کاملEffects of Different Turbulence Models in Simulation of Unsteady Tip Leakage Flow in Axial Compressor Rotor Blades Row
Characteristics of rotor blade tip clearance flow in axial compressors can significantly affect their performance and stable operation. It may also increase blade vibrations and cause detrimental noises. Therefore, this paper is contributed to investigate tip leakage flow in a low speed isolated axial compressor rotor blades row. Simulations are carried out on near-stall condition, which is val...
متن کاملتوسعه یک روش عددی حجم محدود برای ارزیابی عملکرد هیدرودینامیکی سازه های دریایی
Development of a compatible computational fluid dynamics procedure to investigate rigid and fixed/free coastal and offshore structures hydrodynamics in a time-dependent one/two phase flow of viscous incompressible fluids is presented. Differential governing equations are discretised using finite volume approach based on a colocated arrangement. The conservation equations for mass and momentum a...
متن کاملFlow Analysis Heat and Mass Transfer in a Room
This reports the study on the flow behaviour, heat transfer and contamination distribution in a room. For this purpose the 3-D incompressible Navier-Stokes equations, energy equation and a mass transfer equation which model the concentration of contamination have been applied. For turbulence simulation the two equation standard k- turbulence model was employed. By means of SIMPLE algorithm the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Physical review letters
دوره 77 12 شماره
صفحات -
تاریخ انتشار 1996