Enhanced electrocatalytic oxidation of formic acid by platinum deposition on ruthenium nanoparticle surfaces

نویسندگان

  • Wei Chen
  • Li-Ping Xu
  • Shaowei Chen
چکیده

0022-0728/$ see front matter 2009 Elsevier B.V. A doi:10.1016/j.jelechem.2009.03.007 * Corresponding author. E-mail address: [email protected] (S. Che PtRu alloy nanoparticles were prepared by the spontaneous adsorption of Pt(acac)2 on the surface of freshly prepared octanethiolate-protected ruthenium (RuSC8) nanoparticles. UV–vis spectroscopic measurements suggested that the adsorption was facilitated by the strong affinity of the platinum metal center to the ruthenium surface. Scanning tunneling spectroscopic studies showed that the resulting PtRu nanoparticles exhibited enhanced conductance as compared to the original ruthenium nanoparticles, where the adsorbed Pt centers might serve as the effective sites for electron-tunneling across the tip/particle/substrate junction. The nanoparticles were then loaded onto a glassy carbon (GC) electrode and their catalytic activities in the electro-oxidation of formic acid were examined and compared. Remarkably, despite the presence of an organic protecting monolayer on the particle surface, apparent electrocatalytic activity was observed. Voltammetric measurements suggested that a Pt skin layer was formed on the Ru nanoparticle surface, most likely as a result of electro-reduction of the adsorbed Pt(acac)2. On the basis of the onset potential and current density in the electro-oxidation of HCOOH, the resulting PtRu nanoparticles displayed much higher electrocatalytic activity than the Ru counterparts and commercial PtRu nanoparticle catalysts from BASF. It was also found that the electrocatalytic activity of the PtRu nanoparticles was comparable to that of FePt alloy nanoparticles and PtRu bulk electrocatalysts, despite a minimal loading of Pt in the catalysts. Consistent responses were observed in electrochemical impedance spectroscopic measurements, where the charge-transfer resistance on PtRu/GC was found to be at least an order of magnitude smaller than that on Ru/GC and commercial PtRu catalysts. These measurements suggest that the PtRu thin-layer nanoparticles might be used as a promising candidate for the electrocatalytic oxidation of formic acid. 2009 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Iridium-platinum alloy nanoparticles: Composition-dependent electrocatalytic activity for formic acid oxidation†

IrxPt100 x alloy nanoparticles with varied compositions (x1⁄4 100, 75, 67, 50, 34, and 0) were synthesized by a thermolytic process at varied ratios of the IrCl3 and PtCl2 precursors. High-resolution transmission electron microscopic (HRTEM) measurements showed that the nanoparticles all exhibited well-defined crystalline structures with the average core diameters around 2 nm; and the elemental...

متن کامل

Efficient electrocatalytic oxidation of formic acid using Au@Pt dendrimer-encapsulated nanoparticles.

We report electrocatalytic oxidation of formic acid using monometallic and bimetallic dendrimer-encapsulated nanoparticles (DENs). The results indicate that the Au147@Pt DENs exhibit better electrocatalytic activity and low CO formation. Theoretical calculations attribute the observed activity to the deformation of nanoparticle structure, slow dehydration of formic acid, and weak binding of CO ...

متن کامل

Electrocatalytic Activity of Palladium Nanocatalysts Supported on Carbon Nanoparticles in Formic Acid Oxidation

Palladium nanostructures were deposited onto carbon nanoparticle surface by a chemical reduction method. Transmission electron microscopic studies showed that whereas the resulting metal-carbon (Pd-CNP) nanocomposites exhibited a diameter of 20 to 30 nm, the metal components actually showed a cauliflower-like surface morphology that consisted of numerous smaller Pd nanoparticles (3 to 8 nm). El...

متن کامل

Formic acid electrooxidation on thallium-decorated shape-controlled platinum nanoparticles: an improvement in electrocatalytic activity.

Thallium modified shape-controlled Pt nanoparticles were prepared and their electrocatalytic activity towards formic acid electrooxidation was evaluated in 0.5 M sulfuric acid. The electrochemical and in situ FTIR spectroscopic results show a remarkable improvement in the electrocatalytic activity, especially in the low potential region (around 0.1-0.2 V vs. RHE). Cubic Pt nanoparticles modifie...

متن کامل

Sb Surface Modification of Pd by Mimetic Underpotential Deposition for Formic Acid Oxidation

The newly proposed mimetic underpotential deposition (MUPD) technique was extended to modify Pd surfaces with Sb through immersing a Pd film electrode or dispersing Pd/C powder in a Sb(III)-containing solution blended with ascorbic acid (AA). The introduction of AA shifts down the open circuit potential of Pd substrate available to achieve suitable Sb modification. The electrocatalytic activity...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009