Metallurgically Consistent Determination of Steel Hot Strength Using Process Data from Hot Strip Mill Rolling
نویسندگان
چکیده
It is not rare to observe an inverse relationship between hot strength determined from rolling load of the finishing stands of the hot strip mill and strain. This situation was already described in the literature and is explained by the use of inverse rolling load models that assumes sticking friction in the determination of hot strength. The aim of this work was to show that this “work softening” effect is fictitious, disappearing when hot strength is calculated with an inverse rolling load model that properly takes account of the tribological conditions that prevail in the roll gap.
منابع مشابه
Investigations into the Effect of Tension Between the Stands of the Finishing Mill on Width Control in a Hot Rolling Process
This paper is concerned with investigations into the effect of tension between the stands of the finishing mill on width control in a hot rolling process. An analysis is given to predict satisfactorily the variation in width due to spreading and also due to strip tension between the stands. Wusatowskis model which is developed to give an account of spreading is specified and a similar model to ...
متن کاملInvestigations into the Effect of Tension Between the Stands of the Finishing Mill on Width Control in a Hot Rolling Process
This paper is concerned with investigations into the effect of tension between the stands of the finishing mill on width control in a hot rolling process. An analysis is given to predict satisfactorily the variation in width due to spreading and also due to strip tension between the stands. Wusatowski's model which is developed to give an account of spreading is specified and a similar model to...
متن کاملPrediction of Work Roll Initial Crown according to Desired Strip Profile in Hot Rolling
The final hot strip profile is a superposition of the roll initial crown, the roll bending and flattening crown, the roll wearing crown and the roll thermal crown. In this research, linear regression models are proposed to predict the roll force, the roll wearing crown and the roll thermal crown using experimental data provided by Mobarake Steel Complex (MSC). The short beam theory based on ela...
متن کاملPrediction of Work-Piece Constitutive Equation in Hot Rolling of Strip
Dimensional control of the work-piece in steel industry is of important interest. The main aspects in overcoming the thickness control are variations in material strength due to variations in chemical composition, work-piece temperature, reduction and the strain rate applied to the work-piece. In this paper based on the main parameters affecting the rolling force an attempt been made to give a ...
متن کاملSimulation of Temperature Distribution in Hot Strip over Transfer Table
Transfer table is an essential stage between roughing and finishing rolling stands in a hot-strip rolling mill. High temperature and long time that strip is exposed to air at this stage cause a considerable heat loss that accounts for uneven temperature distribution, non-uniform surfaces, reduced product quality and increased production costs. Using thermal shields on the transfer table is cons...
متن کامل