Shear Strength Characteristics in Aged Polyester-glass Fibre Composites
نویسندگان
چکیده
Researches on the effects produced by the sun light upon polymeric matrix composites have been increased on the last ten years. It is commonly to find literature about mechanical characteristics degradation due to different environment effects. But a few ones are related to the shear behaviour. Moreover a limited studies are related to glass fibre polyester, even that are the composites most commonly used, due to its easily elaboration process and to its good cost-performance ratio. Thus, this paper will deal with the study the degradation on the shear behaviour of glass fibre polyester composites exposed to an accelerated simulation with an UV-visible light source. The influence on kind of resin and cured temperature were analysed. The shear degradation fits really close to the mathematical model proposed. Some relations have been found on the shear degradation due to the kind of resin and to the cured temperature.
منابع مشابه
Mechanical and Impact Properties of Untreated Jute Fabric Reinforced Polyester Laminates Compared with Different E- Glass Fibre Reinforced Laminates
In recent years, the improvement of properties of natural fibre reinforced laminates over the pure polymeric matrix has been thoroughly investigated with the aim of providing a possible replacement of E-glass fibre reinforced composites for some large-volume applications. In the present study, the properties of a jute/polyester laminate are compared with those yielded by two E-glass fibre woven...
متن کاملMechanical Characterization of Glass-Basalt-Carbon/Polyester Hybrid Composites
Influence of the stacking sequences of hybrid composites on the tensile strength, flexural strength, inter-laminar shear strength (ILSS) and impact energy was investigated. The hybrid glass-basalt-carbon/polyester composite laminates were processed by hand lay-up procedure at room temperature. The fracture surface of the composite laminates after the tension and flexural test was examined by sc...
متن کاملEffect of Strain Rate on the Tensile Failure of Woven Reinforced Polyester Resin Composites
Tensile stress-strain curves a r e obtained at s t rain rates of %lo-'+, ~ 1 0 and c1000/s for carbon, Kevlar and glass fibre woven-reinforced polyester resin compos i tes and the variation of modulus, tensile strength and fracture strain with strain rate is determined. A change in the failure mode at the highest strain rates is observed for the glass but not the carbon or Kevlar reinforced com...
متن کاملOligomer Coupling Agents in Phosphate Based Glass Fibre / PLA Composites
Oligomer Coupling Agents in Phosphate Based Glass Fibre/PLA Composites P Haque, AJ Parsons, I Ahmed, DJ Irvine, GS Walker, CD Rudd (Univ of Nottingham) Polylactic acid oligomers as coupling agents have showed potentially higher interfacial shear strength in phosphate based glass fibre/ PLA composites. To influence bonding on the glass fibre surface, the short chain PLA with different end groups...
متن کاملThe influence of fibre length, diameter and concentration on the strength and strain to failure of glass-fibre reinforced Polyamide 6,6
Results of an investigation of the mechanical performance of injection moulded long glass fibre reinforced polyamide 6,6 composites are presented. The glass fibre content in these composites was varied over the range 10-50% by weight using fibres with average diameters of 10, 14, and 17 micrometres. Mechanical testing and analysis of the apparent interfacial shear strength was carried out at 23...
متن کامل