Effects of Silane Coupling Agents on the Properties of Copper Filled Electrically Conductive Adhesive
نویسندگان
چکیده
Effects of silane coupling agents with different functional groups such as epoxy, isocyanate and ureide on the electrical and mechanical properties of copper filled electrical conductive adhesives (ECAs) were studied. Copper (Cu) fillers were used as conductive fillers and polyurethane resin was applied as the adhesive material in this study. Significant differences could be observed on the as cured electrical resistivity and shear strength of the Cu filled ECAs prepared with different silane coupling agents. Silane coupling agents functionalized with epoxy groups showed the lowest electrical resistivity and highest shear strength among the ECAs in this study. Besides, effect of post-curing at 170°C for 1 h on the ECAs was also investigated. Results showed that ECAs after post-curing exhibited enhanced electrical conductivity compared to the as cured ECAs. Besides, improved shear strength could be observed for all the ECAs after post-curing.
منابع مشابه
Environmental Aging Effects on the Durability of Electrically Conductive Adhesive Joints
The mechanical behavior of electrically conductive adhesive joints exposed to elevated temperature and relative humidity conditions has been investigated, and failure mechanisms of conductive adhesive joints have been determined. Three model, silver-filled, epoxy-based adhesive systems have been studied in conjunction with printed circuit board (PCB) substrates with metallizations of Au/Ni/Cu a...
متن کاملSilane and bonding of Resins to Ceramic
Silane and bonding of Resins to Ceramic Dr. K. Seyyedan* - Dr. M. Kalalipoor** - Dr. M. Javan***Assistant Professor of Fixed Prosthodontics Dept., Faculty of Dentistry, Shaheed Beheshti University of Medical Sciences. **Resident of Fixed Prosthodontics Dept., Faculty of Dentistry, Shaheed Beheshti University of Medical Sciences. Background and Aim: When bonding between two different dental mate...
متن کاملAdhesive and Conductive – Inkjettable nano-filled inks for use in microelectronics and microsystems technology
Current technology, Inkjet is an accepted technology for dispensing small volumes of material (50 – 500 picolitres). Currently traditional metal-filled conductive adhesives cannot be processed by inkjetting (owing to their relatively high viscosity and the size of filler material particles). Smallest droplet size achievable by traditional dispensing techniques is in the range of 150 μm, yieldin...
متن کاملA Numerical Method for the Determination of an Effective Modules for Coated Glass Fibers Used in Phenolic Composites
It is well known that the mechanical properties of fiberglass reinforced "phenolic moulding compounds" are significantly enhanced if the glass particles are coated with silane coupling agents before compounding. It has been shown that improvements obtained by using scanning electron microscopy techniques are due to better bonding of phenolic resin to the surface of treated glass fibers. These o...
متن کاملSupporting Information for “Critical Factors of the 3D Microstructural Formation in Hybrid Conductive Adhesive Materials by X-ray Nano-tomography”
Appendix 1-Experimental Details Preparation of the conductive adhesive tracks was accomplished by first mechanically mixing a typical thermoset type of adhesive test vehicle with a loading between 78-85 wt% of silver-plated copper to form a uniform paste. The composition is then applied onto a substrate to form conductive traces or electronic circuitry. Usual methods of applying the composition...
متن کامل