Progressive Changes in the Microstructure and Texture in Pearlitic Steel during Wire Drawing
نویسندگان
چکیده
The evolution of microstructure and texture during wire drawing of pearlitic steel was studied using scanning electron microscopy and X-ray diffraction. Wire drawing induces elongation of ferrite grains with the development of <110> fibre texture. The cementite lamellae also have a tendency to reorient themselves along the wire axis with increasing strain. Viscoplastic self-consistent simulations were employed to simulate the texture evolution in the ferrite phase.
منابع مشابه
Developing Very Fine Nanopearlitic Structure in a High Carbon Steel Wire before Drawing
The effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. In this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. The results were the minimum interlamellar spacing of 35 nm and maximum ulti...
متن کاملOptimization of Mechanical Properties of High-Carbon Pearlitic Steels with SI and V Additions
continuous grain-boundary cementite can form and cause THE primary requirements for high-strength wire appliembrittlement.[4,5] Nevertheless, we have found that it is cations are tensile strength, ductility, and formability. Coldpossible to use pearlitic steels with carbon contents greater drawn plain-carbon pearlitic steels have commonly been than 0.8 wt pct without the formation of a continuo...
متن کاملAnalysis of Fatigue Crack Paths in Cold Drawn Pearlitic Steel
In this paper, a fracto-metallographic analysis was performed on the cracked specimens of cold drawn pearlitic steel subjected to fatigue tests. Fatigue cracks are transcollonial and exhibit a preference for fracturing pearlitic lamellae, with non-uniform crack opening displacement values, micro-discontinuities, branchings, bifurcations and frequent local deflections that create microstructural...
متن کاملRecrystallization Behavior of Deep Drawing Low Carbon Steel Sheets Produced by Mobarakeh Steel Plant
In the present work the recrystallization behavior of deep drawing grade Al-killed low carbon steel sheets produced by Mobarakeh Steel Plant (MSP) has been studied. Salt bath isothermal annealing has b...
متن کاملIndian Institute of Technology Kharagpur Comparison of Globularisation Behaviour during Reheating Treatment of Different Pearlitic Microstructures
Pearlitic steels present very interesting mechanical properties when weldability requirements are not too severe. Thin gauge pearlitic steels require at least one intermediate annealing treatment between hot rolling and cold rolling. The globularised cementite in medium carbon steels provides then higher ductility, formability and machinability. On the other hand, in-line induction heating devi...
متن کامل