Frequency-Quantizer-Based Digital LDO with Built-In Adaptive Sampling and Active Voltage Positioning

Integrated voltage regulators with a wide output current/voltage dynamic range are required to support fast dynamic voltage and frequency scaling (DVFS). Low Dropout Regulators (LDOs) based on digital-intensive circuits have been gaining popularity [1]–[4] due to their compactness, process scalability, high immunity to process-voltage-temperature (PVT) variations and easy programmability for design optimization. Conventional digital LDOs utilizing a comparator and shiftregisters [1] suffer from a slow response time during a large/fast change in load current (ILOAD). Higher sampling frequency (fS) improves the response time, but at the cost of increased power consumption and reduced loop stability. Multi-bit quantizers utilizing ADCs [2-4] can reduce the settling time, however, the presence of a high resolution ADC and the control logic increases the design complexity. Moreover, the ADC resolution limits the maximum fS. In order to overcome the trade-off between speed and power, adaptive sampling techniques were incorporated in [1], [4]. But the overhead of multiple VCOs operating simultaneously and a separate overshoot/droop detection circuitry [1], or an event-driven controller with 7b ADC [4], increase the complexity and power consumption. Furthermore, none of the previous designs incorporated active voltage positioning (AVP), a popular ripple-suppression technique, whereby the LDO output is set slightly above (in low-activity state) or below (in high-activity state) the reference voltage depending on the processor workload conditions [5].