COMPARATIVE STUDY OF CYTOTOXICITY OF DIRECT METAL LASER SINTERED AND CAST Co-Cr-Mo DENTAL ALLOY
نویسنده
چکیده
T. Puskar, Department of Dentistry, Medical Faculty, University of Novi Sad, Serbia. A. Lapcevic, D. Jevremovic, Clinic for Prosthodontics, School of Dentistry Pančevo, University Business Academy, Novi Sad, Serbia. S. Arandjelovic, S. Radulovic, Institute for Oncology and Radiology of Serbia, Belgrade, Serbia. I. Budak, Dj. Vukelic, Faculty of Technical Sciences, University of Novi Sad, Novi Sad, Serbia. The presented work investigated the cytotoxicity of direct metal laser sintered (DMLS) and cast Co-Cr-Mo (CCM) dental alloy. In vitro tests were done on human fibroblast cell line MRC-5. There was no statistically significant difference in the cytotoxic effects of DMLS and CCM alloy specimens. The results of this investigation show good potential of DMLS Co-Cr-Mo alloy for application in dentistry.
منابع مشابه
Comparative study between laser sintering and casting for retention of resin composite veneers to cobalt-chromium alloy.
The purpose of this study was to evaluate and compare the bond strengths between resin composite veneer and laser-sintered cobalt-chromium (Co-Cr) alloy with and without retention devices (Laser-R and Laser-N respectively). Cast Co-Cr alloy with and without retention devices (Cast-R and Cast-N respectively) were also prepared for fabrication technique comparison. Disk-shaped Co-Cr alloy specime...
متن کاملComparison of Dental Prostheses Cast and Sintered by SLM from Co-Cr-Mo-W Alloy
The article presents the results of a comparative analysis of the metal substructure for dental prosthesis made from a Co-Cr-Mo-W alloy by two techniques, i.e. precision investment casting and selective laser melting (SLM). It was found that the roughness of the raw surface of the SLM sinter is higher than the roughness of the cast surface, which is compensated by the process of blast cleaning ...
متن کاملVertical misfit of laser-sintered and vacuum-cast implant-supported crown copings luted with definitive and temporary luting agents
OBJECTIVES This study aimed to evaluate the vertical discrepancy of implant-supported crown structures constructed with vacuum-casting and Direct Metal Laser Sintering (DMLS) technologies, and luted with different cement types. STUDY DESIGN Crown copings were fabricated using: (1) direct metal laser sintered Co-Cr (LS); (2) vacuum-cast Co-Cr (CC); and (3) vacuum-cast Ti (CT). Frameworks were ...
متن کاملComparison of internal fit between implant abutments and cast metal crowns vs laser-sintered crowns.
AIM A common problem related to cemented single crowns is the internal misfit, which may cause inadequate retention, especially when seated on the implant abutment. The aim of this study was to compare the internal fit of Co-Cr crowns using a traditional lost-wax casting technique from laser-sintered Co-Cr alloy crowns. MATERIALS AND METHODS Twelve metallic crowns per each technique were fabr...
متن کاملComparison of the mechanical properties and microstructures of fractured surface for Co-Cr alloy fabricated by conventional cast, 3-D printing laser-sintered and CAD/CAM milled techniques
Cobalt-Chromium (Co-Cr) alloys have been widely used in dentistry for removable partial dentures, metal frames, and porcelain-fused-to-metal crowns. Because the alloys are strong, resistant to corrosion and relatively inexpensive compared to gold alloys and some all-ceramic materials. However, the fabrication processes for the alloys, such as casting, cutting and plastic works, are usually diff...
متن کامل