Fabrication and characterization of an electrically contacted vapor cell.
نویسندگان
چکیده
We demonstrate the use of electrically contacted vapor cells to switch the transmission of a probe laser. The excitation scheme makes use of electromagnetically induced transparency involving a Rydberg state. The cell fabrication technique involves thin-film-based electric feedthroughs, which are well suited for scaling this concept to many addressable pixels like in flat panel displays.
منابع مشابه
Electrical characterization of graphene synthesized by chemical vapor deposition using Ni substrate.
In this work, the electrical characterization of graphene films grown by chemical vapor deposition (CVD) on a Ni thin film is carried out and a simple relation between the gate-dependent electrical transport and the thickness of the films is presented. Arrays of two-terminal devices with an average graphene film thickness of 6.9 nm were obtained using standard fabrication techniques. A simple t...
متن کاملFabrication and Characterization of a Conductive Proton Exchange Membrane Based on Sulfonated Polystyrenedivinylbenzene Resin-Polyethylene (SPSDR-PE): Application in Direct Methanol Fuel Cells
A novel proton exchange membrane has been prepared using sulfonated poly(styrene-divinylbenzene) resin(SPSDR)–polyethylene(PE). The membrane is characterized by FT-IR, SEM and TGA/DSC. Water uptake, oxidative resistance, ionic conductivity and methanol permeability are measured to evaluate its performance in a direct methanol fuel cell. The on-set degradation temp...
متن کاملFABRICATION AND CHARACTERIZATION OFHIGH PERFORMANCE CERAMIC MEMBRANE HAVINGNANOMETRE PORES
Abstract: In this study, carbon nanotubes (CNTs) were grown directly in the pores of micro porous pyrex membranesand consequently ceramic membranes with very fine pores and high porosity were achieved. Our experiment was donein two stages. Initially cobalt powder with different percent was homogeneously mixed with pyrex powder. In order toproduce row membranes, each of these mixtures were compa...
متن کاملFabrication, characterization and investigation of gas sensing properties of MoO3 thin films
In this research, molybdenum oxide (α-MoO3) thin films were coated on glass substrates using spray pyrolysis technique. 0.05 M ammonium heptamolybdate tetrahydrate was used as precursor and deionized water as solvent. The effects of carrier gas pressure, during the spraying of the solution, on the structural, optical, morphological and gas sensing properties of thin films were studied. X-ray di...
متن کاملAn Overview and Feasibility Study of Fabrication Technology and Characterization Techniques of Erbium-Doped Fiber amplifiers in Iran
In this paper, a brief summary of different methods of fabrication of optical preform and fiber is reviewed. Several methods of incorporation of erbium ions into optical preforms are studied. Characterization of the fabricated erbium doped fibers including measurements of refractive index profile, absorption, fluorescence and gain spectra and metastable lifetime are described. It is also expres...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics letters
دوره 37 12 شماره
صفحات -
تاریخ انتشار 2012