Optimal loop bandwidth design for low noise PLL applications
نویسندگان
چکیده
| This paper presents a salient method to nd an optimal bandwidth for low noise phase-locked loop (PLL) applications by analyzing a discrete-time model of charge-pump PLLs based on ring oscillator VCOs. The analysis shows that the timing jitter of the PLL system depends on the jitter in the ring oscillator and an accumulation factor which is inversely proportional to the bandwidth of the PLL. Further analysis shows that the timing jitter of the PLL system, however, proportionally depends on the bandwidth of the PLL when an external jitter source is applied. The analysis of the PLL timing jitter of both cases gives the clue to the optimal bandwidth design for low noise PLL applications. Simulation results using a C-language PLL model are compared with the theoretical predictions and show good agreement.
منابع مشابه
Design of Gate-Driven Quasi Floating Bulk OTA-Based Gm–C Filter for PLL Applications
The advancement in the integrated circuit design has developed the demand for low voltage portable analog devices in the market. This demand has increased the requirement of the low-power RF transceiver. A low-power phase lock loop (PLL) is always desirable to fulfill the need for a low power RF transceiver. This paper deals with the designing of the low power transconductance- capacitance (Gm-...
متن کاملA-New-Closed-form-Mathematical-Approach-to-Achieve Minimum Phase Noise in Frequency Synthesizers
The aim of this paper is to minimize output phase noise for the pure signal synthesis in the frequency synthesizers. For this purpose, first, an exact mathematical model of phase locked loop (PLL) based frequency synthesizer is described and analyzed. Then, an exact closed-form formula in terms of synthesizer bandwidth and total output phase noise is extracted. Based on this formula, the phase ...
متن کاملDesign of robust carrier tracking systems in high dynamic and high noise conditions, with emphasis on neuro-fuzzy controller
The robust carrier tracking is defined as the ability of a receiver to determine the phase and frequency of the input carrier signal in unusual conditions such as signal loss, input signal fading, high receiver dynamic, or other destructive effects of propagation. An implementation of tight tracking can be understood in terms of adopting a very narrow loop bandwidth that contradict with the req...
متن کاملPLL Basics.fm
Unfortunately, most of the articles and books written about designing the Loop Filter for PLL synthesizers dwell in the theoretical and try to cover the subject for all cases of PLL synthesizer design. This article will consider the design of a simple passive three-pole Loop Filter typically used in low voltage, low operating bandwidth synthesizer applications. This approach will simplify and d...
متن کاملA new PLL design for clock management applications
In this paper we describe a novel Phase-Locked Loop (PLL) design for clock management applications. Such PLLs should operate over a wide range of frequencies, have tight constraints on jitter, power consumption and acquisition time, while being dynamically programmable by software means. In addition to the conventional fine tuning loop, the PLL has a coarse tuning loop to control the operating ...
متن کامل