CO2 Capture from Flue Gas by Phase Transitional Absorption

Experimental Studies of CO2 Capturing from the Flue Gases

CO2 emissions from combustion flue gases have turned into a major factor in global warming. Post-combustion carbon capture (PCC) from industrial utility flue gases by reactive absorption can substantially reduce the emissions of the greenhouse gas CO2. To test a new solvent (AIT600) for this purpose, a small pilot plant was used. This paper presents the results of studies ...

A computational investigation on the structural features of alkanolamine solvents for CO2 capture process from power plant flue gas

Development of New Potassium Carbonate Sorbent for CO2 Capture under Real Flue Gas Conditions

In this paper, the development of a new potassium carbonateon alumina support sorbent prepared by impregnating K2CO3 with an industrial grade of Al2O3 support was investigated. The CO2 capture capacity was measured using real flue gas with 8% CO2 and 12% H2O in a fixed-bed reactor at a temperature of 65 °C using breakthrough curves. The developed sorbent showed an adsorption capacity of 66.2 mg...

Membrane-Cryogenic Post-Combustion Carbon Capture of Flue Gases from NGCC

Membrane gas separation for carbon capture has traditionally been focused on high pressure applications, such as pre-combustion capture and natural gas sweetening. Recently a membrane-cryogenic combined process has been shown to be cost competitive for post-combustion capture from coal fired power stations. Here, the membrane-cryogenic combined process is investigated for application to post-co...

Flue gas treatment for CO2 capture

This report is in two sections: the first describes the flue gas and its treatment in post-combustion capture and the second covers the flue gas in oxyfuel combustion capture. The main components of the flue gas in pulverised coal combustion for postcombustion capture are CO2, N2, O2 and H2O, and air pollutants such as SOx, NOx, particulates, HCl, HF, mercury as well as other contaminants. The ...