Static Friction Experiments and Verification of an Improved Elastic-Plastic Model Including Roughness Effects
نویسندگان
چکیده
An experimental study was conducted to measure the static friction coefficient under constant normal load and different interface conditions. These include surface roughness, dwell time, displacement rate, as well as the presence of traces of lubricant and wear debris at the interface. The static friction apparatus includes accurate measurement of friction, normal and lateral forces at the interface (using a high dynamic bandwidth piezoelectric force transducer), as well as precise motion control and measurement of the sliding mass. The experimental results show that dry surfaces are more dependent on the displacement rate prior to sliding inception compared to boundary lubricated surfaces in terms of static friction coefficient. Also, the presence of wear debris, boundary lubrication, and rougher surfaces decrease the static friction coefficient significantly compared to dry smooth surfaces. The experimental measurements under dry unlubricated conditions were subsequently compared to an improved elastic-plastic static friction model, and it was found that the model captures the experimental measurements of dry surfaces well in terms of the surface roughness. DOI: 10.1115/1.2768074
منابع مشابه
A Static Friction Model for Elastic-Plastic Contacting Rough Surfaces
A model that predicts the static friction for elastic-plastic contact of rough surfaces is presented. The model incorporates the results of accurate finite element analyses for the elastic-plastic contact, adhesion and sliding inception of a single asperity in a statistical representation of surface roughness. The model shows strong effect of the external force and nominal contact area on the s...
متن کاملEffect of surface roughness on steel-steel dry friction coefficient
The influence of surface roughness magnitude and direction on dry static friction coefficient between two similar steel samples has been studied through an experiment. A testing apparatus has been designed and fabricated to measure the friction coefficient for a few forms of surface asperity. According to the results of the experiments, dry friction coefficient is affected by both magnitude and...
متن کاملA Sub Loading Surface Multilaminate Model for Elastic-Plastic Porous Media
A framework for development of constitutive models based on semi-micromechanical aspects of plasticity is proposed. The resulting of this model for material employed friction type failure criterion, sub-loading surface, and associated flow rule. This model is capable of predicting effects of the rotation of principal stress/strain axes and consequent plastic flow, induced anisotropy of strength...
متن کاملAccuracy of Discrete Element Method Simulations: Rolling and Sliding Frictions Effects-Case study: Iron Ore Pellets
The discrete element method (DEM) has been used as a popular simulation method in order to verify the designs by visualizing how materials flow through complex equipment geometries. Although DEM simulation is a powerful design tool, finding a DEM model that includes all real material properties is not computationally feasible. In order to obtain more realistic results, particle energy loss du...
متن کاملEffect of normal load and roughness on the nanoscale friction coefficient in the elastic and plastic contact regime
The influence of applied normal load and roughness on the tribological behavior between the indenter and sample surface during nanoindentation-based scratching has been experimentally investigated by using different surfaces (fused silica and diamond-like carbon) featuring various degrees of roughness. At a sufficiently low applied normal load, wherein the contact is elastic, the friction coeff...
متن کامل