Suture locking of isolated internal locking knotless suture anchors is not affected by bone quality

نویسندگان

  • Jarret M Woodmass
  • Graeme Matthewson
  • Yohei Ono
  • Aaron J Bois
  • Richard S Boorman
  • Ian KY Lo
  • Gail M Thornton
چکیده

PURPOSE The purpose of this study was to evaluate the mechanical performance of different suture locking mechanisms including: i) interference fit between the anchor and the bone (eg, 4.5 mm PushLock, 5.5 mm SwiveLock), ii) internal locking mechanism within the anchor itself (eg, 5.5 mm SpeedScrew), or iii) a combination of interference fit and internal locking (eg, 4.5 mm MultiFIX P, 5.5 mm MultiFIX S). METHODS Anchors were tested in foam blocks representing normal (20/8 foam) or osteopenic (8/8 foam) bone, using standard suture loops pulled in-line with the anchor to isolate suture locking. Mechanical testing included cyclic testing for 500 cycles from 10 N to 60 N at 60 mm/min, followed by failure testing at 60 mm/min. Displacement after 500 cycles at 60 N, number of cycles at 3 mm displacement, load at 3 mm displacement, and maximum load were evaluated. RESULTS Comparing 8/8 foam to 20/8 foam, load at 3 mm displacement and maximum load were significantly decreased (P<0.05) with decreased bone quality for anchors that, even in part, relied on an interference fit suture locking mechanism (ie, 4.5 mm PushLock, 5.5 mm SwiveLock, 4.5 mm MultiFIX P, 5.5 mm MultiFIX S). Bone quality did not affect the mechanical performance of 5.5 mm SpeedScrew anchors which have an isolated internal locking mechanism. CONCLUSION The mechanical performance of anchors that relied, even in part, on interference fit were affected by bone quality. Isolated internal locking knotless suture anchors functioned independently of bone quality. Anchors with a combined type (interference fit and internal locking) suture locking mechanism demonstrated similar mechanical performance to isolated internal locking anchors in osteopenic foam comparing similar sized anchors. CLINICAL RELEVANCE In osteopenic bone, knotless suture anchors that have an internal locking mechanism (isolated or combined type) may be advantageous for secure tendon fixation to bone.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Knotless anchors with sutures external to the anchor body may be at risk for suture cutting through osteopenic bone

OBJECTIVES This study evaluated the mechanical performance, under low-load cyclic loading, of two different knotless suture anchor designs: sutures completely internal to the anchor body (SpeedScrew) and sutures external to the anchor body and adjacent to bone (MultiFIX P). METHODS Using standard suture loops pulled in-line with the rotator cuff (approximately 60°), anchors were tested in cad...

متن کامل

Comparison of the Fixation Strength of PEEK Knotless Suture Anchors for Rotator Cuff Repair

INTRODUCTION Rotator cuff injuries are common, with approximately 400,000 cuff repairs performed each year in the United States alone. Surgical repair of torn cuff tendons involves reattachment of the torn end of the tendon to the original footprint on the proximal humerus, typically using suture anchors. In recent years, suture anchors have evolved into knotless systems, which are designed to ...

متن کامل

Quadriceps Tendon Repair Using Knotless Anchors and Suture Tape

Repair of a torn quadriceps tendon is necessary to restore the extensor mechanism of the knee. Traditional repair involves transosseous sutures tied over bone bridges on the inferior pole of the patella. Suture anchor repair has been shown to be stronger than transosseous repair and facilitates a smaller incision. Suture tape can improve the strength of the suture-tendon interface, and when com...

متن کامل

Knotless single-row rotator cuff repair: a comparative biomechanical study of 2 knotless suture anchors.

The purpose of this study was to compare the gap formation during cyclic loading, maximum repair strength, and failure mode of single-row full-thickness supraspinatus repairs performed using 2 knotless suture anchors with differing internal suture-retention mechanisms in a human cadaver model. Nine matched pairs of cadaver shoulders were used. Full-thickness tears were induced by detaching the ...

متن کامل

Pullout strength of knotless suture anchors.

PURPOSE Suture anchors are used consistently for repairs of soft tissues, especially around the glenohumeral joint. These anchors can be used either arthroscopically or in an open procedure to anatomically restore the labrum and capsular tissues to the glenoid after avulsion injuries (Bankart lesion). The purpose of this study was to analyze the pullout strength of a new knotless suture anchor ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2015