Dynamics of Adiabatic Shear

نویسنده

  • D. Grady
چکیده

The formation of adiabatic shear bands is examined with an approximate analytic model. The shear band is viewed as a propagating feature with a well-defined front. The shear band is further partition into a shear-band process zone within which most of the adiabatic heating and shear stress relaxation occurs, followed by a quasisteady zone within which little dissipation occurs. Although a one-dimensional analysis of the shear-band dynamics is initially pursued, the analysis is then used to calculate properties of the inherently two-dimensional shearband process zone. The length and width of the process zone is calculated along with the shear displacement. The model is further used to calculate the energy dissipation within the shear-band process zone. The flow field within the vicinity of the process zone is also examined. Calculated properties of the shear-band process zone are compared with available experimental data.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Nonlinear stresses and temperatures in transient adiabatic and shear flows via nonequilibrium molecular dynamics: Three definitions of temperature.

We compare nonlinear stresses and temperatures for adiabatic-shear flows, using up to 262, 144 particles, with those from corresponding homogeneous and inhomogeneous flows. Two varieties of kinetic temperature tensors are compared to the configurational temperatures. This comparison of temperatures led us to two findings beyond our original goal of analyzing shear algorithms. First, we found an...

متن کامل

On acoustic wave generation in uniform shear flow

M. Akhalkatsi Physics Department, Tbilisi State University, Tbilisi 0179, Georgia (Dated: October 2004) Abstract The linear dynamics of acoustic waves and vortices in uniform shear flow is studied. For flows with very low shear rates, the dynamics of perturbations is adiabatic and can be described by the WKB approximation. However, for flows with moderate and high shear rates the WKB approximat...

متن کامل

Changing shapes: adiabatic dynamics of composite solitary waves

We discuss the solitary wave solutions of a particular two-component scalar field model in twodimensional Minkowski space. These solitary waves involve one, two or four lumps of energy. The adiabatic motion of these composite non-linear non-dispersive waves points to variations in shape.

متن کامل

Dynamic recrystallization as a potential cause for adiabatic shear failure.

Dynamic recrystallization (DRX) is almost universally observed in the microstructure of adiabatic shear bands. It is usually admitted that DRX results from the large temperatures that develop in the band along with very high local strains. This paper reports the observation of dynamically recrystallized nanograins in Ti6Al4V alloy specimens that were impact loaded to only half the failure strai...

متن کامل

An Investigation into the Microstructure of Adiabatic Shear Banding in AISI 1045 Hardened Steel due to High Speed Machining C.Z.Duan

Adiabatic shear banding during high speed machining is important to understand material removal mechanisms. This paper investigates the microstructure of adiabatic shear bands (ASBs) in the serrated chips produced during the high speed machining of AISI 1045 hardened steel. Optical microscope, scanning electronic microscope(SEM) and transmission electronic microscope(TEM) were used to explore t...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016