Tool Path Generation and Manufacturing Process for Blades of a Compressor Rotor
ثبت نشده
چکیده
This paper presents a complete procedure for tool path planning and blade machining in 5-axis manufacturing. The actual cutting contact and cutter locations can be determined by lead and tilt angles. The tool path generation is implemented by piecewise curved approximation and chordal deviation detection. An application about drive surface method promotes flexibility of tool control and stability of machine motion. A real manufacturing process is proposed to separate the operation into three regions with five stages and to modify the local tool orientation with an interactive algorithm. Keywords—5-axis machining, tool orientation, lead and tilt angles, tool path generation.
منابع مشابه
Effect of aging and manufacturing tolerances on multi-stage transonic axial compressor performance
The Axial compressor is an integrated part of a gas turbine. The central part of compressors is its blades. Blade aerodynamic has a significant effect on compressor performance. Because of the adverse pressure gradient in the compressor, any deviation in the blade profile has a significant influence on the flow field as well as the compressor performance. During the manufacturing and operation ...
متن کاملEffects of Impeller Gap on Rotor Vibration in a High Speed Centrifugal Compressor: A Numerical and Experimental Analysis (TECHNICAL NOTE)
Centrifugal compressors produce high pressure ratio and rotate at speeds. So, a tiny unbalance can produce severe vibration. In this paper, effects of impeller gap on rotor vibration in a high speed centrifugal compressor is investigated. For this purpose, a numerical and experimental analysis are carried out. The moving reference frame method in FLUENT software is used for modeling of geometri...
متن کاملEffects of Different Turbulence Models in Simulation of Unsteady Tip Leakage Flow in Axial Compressor Rotor Blades Row
Characteristics of rotor blade tip clearance flow in axial compressors can significantly affect their performance and stable operation. It may also increase blade vibrations and cause detrimental noises. Therefore, this paper is contributed to investigate tip leakage flow in a low speed isolated axial compressor rotor blades row. Simulations are carried out on near-stall condition, which is val...
متن کاملOne-Dimensional design of a three-stage axial compressor with Its 3D numerical simulation
The purpose of this study is to design a three-stage axial compressor with identical pressure ratio which makes an adequate pressure ratio and efficiency in design point conditions with rotational velocity of 38000rpm and mass flow rate of 3.2kg/s. First of all, considering some restrictions such as Dehaller number more than 0.7 in all sections of the stator and the rotor, and relative Mach num...
متن کاملA 2-D Numerical Investigation on the Modal Characteristics of Rotating-Stall with a Variable-Cascade- Length Approach in an Axial Compressor
The Rotating-Stall (RS) through a rotor-cascade of an axial compressor were numerically investigated with an unsteady two-dimensional finite-volume density based computer code. To validate the computer code, a test case was prepared and the good agreement of the compared results has given the adequate assurance of the code. The RS was incepted with a 40% reduction in flow coefficient and a 0.4%...
متن کامل