Multiple Controlled Synchronization for 3-Rotor Vibration Unit with Varying Payload
نویسندگان
چکیده
Alexander Fradkov*. Olga Tomchina** Viktoria Galitskaya***. Dmitry Gorlatov**** * Institute of Problems of Mechanical Engineering, Russian Academy of Sciences, Saint Petersburg, Russia (Tel: 812-321-4410; e-mail: [email protected]) ** Saint Petersburg State Polytechnical University, Saint Petersburg, Russia (e-mail: [email protected]) *** Saint Petersburg State Polytechnical University, Saint Petersburg, Russia (e-mail: [email protected]) **** Saint Petersburg State Polytechnical University, Saint Petersburg, Russia (e-mail: [email protected])
منابع مشابه
Microsoft Word - kr-syn-nest-nabl07.DOC
1. Introduction During recent years the speed-gradient algorithms developed in control engineering area [1,2] have been applied intensively to control of oscillatory motion and particularly to control of vibration units. Among problems solved by speed-gradient approach are control of vibration units in start-up modes (swing-up and passage through resonance) [ 3-5], synchronization [6-8], etc. O...
متن کاملA magnetorheological fluid damper for robust vibration control of flexible rotor-bearing systems: A comparison between sliding mode and fuzzy approaches
Squeeze Film Dampers (SFD) are commonly used for passive vibration control of rotor-bearing systems. The Magnetorheological (MR) and Electrorheological (ER) fluids in SFDs give a varying damping characteristic to the bearing that can provide active control schemes for the rotor-bearing system. A common way to model an MR bearing is implementing the Bingham plastic model. Adding this model to th...
متن کاملInvestigating Nonlinear Vibration Behavior of Rotors with Asymmetry Shaft Considering Misalignment
In this paper, the nonlinear vibration behavior of a rotor with asymmetric shaft considering misalignment is studied. The system consists of a rectangular shaft and a disk which is connected to a motor through a flexible coupling. In order to consider higher order deformations, nonlinear Bernoulli beam is used for modeling the shaft. Gibbons’ equations are utilized to apply misaligned coupling ...
متن کاملOptimal One-plane Active Balancing of a Rigid Rotor during Acceleration
Rotating machinery, including machining spindles, industrial turbomachinery, and aircraft gas turbine engines, are very commonly used in industry. One major problem faced by these machineries is the harmful, imbalance-induced vibration. Many methods have been developed to reduce this vibration: o!-line balancing methods [1], on-line active balancing methods using mass redistribution devices [2}...
متن کاملApplication of Model Predictive Control for Improving Stability of Rotor and Controlling Active Rotor Vibration
The aim of this paper is to study the application of model predictive controller for improving stability of rotor and rotor vibration. Rotor vibrations in electrical machines are dampen out by model predictive control algorithm. The controlled system is the one dimensional Jeffcott-rotor. Model predictive control algorithm was designed, and the simulation results were obtained by Mat lab softwa...
متن کامل