Lung stress and strain during mechanical ventilation: any difference between statics and dynamics?
نویسندگان
چکیده
OBJECTIVE Tidal volume (VT) and volume of gas caused by positive end-expiratory pressure (VPEEP) generate dynamic and static lung strains, respectively. Our aim was to clarify whether different combinations of dynamic and static strains, resulting in the same large global strain, constantly produce lung edema. DESIGN Laboratory investigation. SETTING Animal unit. SUBJECTS Twenty-eight healthy pigs. INTERVENTIONS After lung computed tomography, 20 animals were ventilated for 54 hours at a global strain of 2.5, either entirely dynamic (VT 100% and VPEEP 0%), partly dynamic and partly static (VT 75-50% and VPEEP 25-50%), or mainly static (VT 25% and VPEEP 75%) and then killed. In eight other pigs (VT 25% and VPEEP 75%), VPEEP was abruptly zeroed after 36-54 hours and ventilation continued for 3 hours. MEASUREMENTS AND MAIN RESULTS Edema was diagnosed when final lung weight (balance) exceeded the initial weight (computed tomography). Mortality, lung mechanics, gas exchange, pulmonary histology, and inflammation were evaluated. All animals ventilated with entirely dynamic strain (VT 825±424 mL) developed pulmonary edema (lung weight from 334±38 to 658±99 g, p<0.01), whereas none of those ventilated with mainly static strain (VT 237±21 mL and VPEEP 906±114 mL, corresponding to 19±1 cm H2O of positive end-expiratory pressure) did (from 314±55 to 277±46 g, p=0.65). Animals ventilated with intermediate combinations finally had normal or largely increased lung weight. Smaller dynamic and larger static strains lowered mortality (p<0.01), derangement of lung mechanics (p<0.01), and arterial oxygenation (p<0.01), histological injury score (p=0.03), and bronchoalveolar interleukin-6 concentration (p<0.01). Removal of positive end-expiratory pressure did not result in abrupt increase in lung weight (from 336±36 to 351±77 g, p=0.51). CONCLUSIONS Lung edema forms (possibly as an all-or-none response) depending not only on global strain but also on its components. Large static are less harmful than large dynamic strains, but not because the former merely counteracts fluid extravasation.
منابع مشابه
Lung regional stress and strain as a function of posture and ventilatory mode.
During positive-pressure ventilation parenchymal deformation can be assessed as strain (volume increase above functional residual capacity) in response to stress (transpulmonary pressure). The aim of this study was to explore the relationship between stress and strain on the regional level using computed tomography in anesthetized healthy pigs in two postures and two patterns of breathing. Airw...
متن کاملReducing lung strain after pneumonectomy impairs oxygen diffusing capacity but not ventilation-perfusion matching.
After pneumonectomy (Pnx), mechanical strain on the remaining lung is an important signal for adaptation. To examine how mechanical lung strain alters gas exchange adaptation after Pnx, we replaced the right lung of adult dogs with a custom-shaped inflatable silicone prosthesis. The prosthesis was kept 1) inflated (Inf) to reduce mechanical strain of the remaining lung and maintain the mediasti...
متن کاملMechanical properties of CNT reinforced nano-cellular polymeric nanocomposite foams
Mechanics of CNT-reinforced nano-cellular PMMA nanocomposites are investigated using coarse-grained molecular dynamics simulations. Firstly, static uniaxial stretching of bulk PMMA polymer is simulated and the results are compared with literature. Then, nano-cellular foams with different relative densities are constructed and subjected to static uniaxial stretching and obtained stress-strain cu...
متن کاملMechanical Characteristics and Failure Mechanism of Nano-Single Crystal Aluminum Based on Molecular Dynamics Simulations: Strain Rate and Temperature Effects
Besides experimental methods, numerical simulations bring benefits and great opportunities to characterize and predict mechanical behaviors of materials especially at nanoscale. In this study, a nano-single crystal aluminum (Al) as a typical face centered cubic (FCC) metal was modeled based on molecular dynamics (MD) method and by applying tensile and compressive strain loadings its mechanical ...
متن کاملTransient Mechanical Response of Lung Airway Tissue during Mechanical Ventilation
Patients with acute lung injury, airway and other pulmonary diseases often require Mechanical Ventilation (MV). Knowledge of the stress/strain environment in lung airway tissues is very important in order to avoid lung injuries for patients undergoing MV. Airway tissue strains responsible for stressing the lung's fiber network and rupturing the lung due to compliant airways are very difficult t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Critical care medicine
دوره 41 4 شماره
صفحات -
تاریخ انتشار 2013