Effects of the preparation method of the ternary CdS/TiO2/Pt hybrid photocatalysts on visible light-induced hydrogen production†

نویسندگان

  • Hyunwoong Park
  • Wonyong Choi
  • Michael R. Hoffmann
چکیده

A variety of combinations of CdS, TiO2, and Pt in preparing the hybrid catalysts were studied for hydrogen production under visible light (l > 420 nm) irradiation. The preparation method sensitively influenced the activity of the ternary hybrid catalysts. The formation of the potential gradient at the interface between CdS and TiO2 is necessary in achieving the efficient charge separation and transfer and how the platinum as a cocatalyst is loaded onto the CdS/TiO2 hybrid catalysts determines the overall hydrogen production efficiency. The common method of photoplatinization of CdS/TiO2 hybrid [Pt-(CdS/TiO2)] was much less efficient than the present method in which Pt was photodeposited on bare TiO2, which was followed by the deposition of CdS [CdS/(Pt-TiO2)]. The CdS/(Pt-TiO2) has the hydrogen production rate ranging (6–9) 10 3 mol h 1 g , which is higher by a factor of 3–30 than that of Pt-(CdS/TiO2). The photocatalytic activity of the ternary hybrid catalysts was extremely sensitive to where the platinum is loaded. The photoactivity of the hybrid catalyst was also assessed in terms of the photocurrent collected by the methyl viologen electron shuttle in the catalyst suspension. CdS/(Pt-TiO2) generated higher photocurrents than Pt-(CdS/TiO2) by a factor of 2–7. The extreme sensitivity of the preparation method to the hydrogen production activity should be taken into account when hybrid photocatalysts are designed and prepared.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Development of Visible-light-active Photocatalyst for Hydrogen Production and Environmental Application

Semiconductor photocatalysis has been intensively studied in recent decades for a wide variety of application such as hydrogen production from water splitting and water and air treatment. The majority of photocatalysts are, however, wide band-gap semiconductors which are active only under UV irradiation. In order to effectively utilize visible solar radiation, this thesis investigates various t...

متن کامل

Biomolecule-mediated CdS-TiO2-reduced graphene oxide ternary nanocomposites for efficient visible light-driven photocatalysis.

We report an environmentally friendly synthetic strategy to fabricate reduced graphene oxide (rGO)-based ternary nanocomposites, in which glutathione (GSH) acts both as a reducing agent for graphene oxide and sulfur donor for CdS synthesis under modified hydrothermal (MHT) conditions. The report becomes interesting as pH variation evolves two distinctly different semiconducting nanocrystals of ...

متن کامل

Controllable fabrication of immobilized ternary CdS/Pt-TiO2 heteronanostructures toward high-performance visible-light driven photocatalysis.

Immobilized TiO2 nanotube arrays (NTAs) co-modified with Pt and CdS nanoparticles were fabricated by using the combination of photoreduction and chemical bath deposition methods. XRD, SEM, TEM, XPS, UV-Vis and EDX methods were employed to characterize the microstructure and composition of samples, and the results showed that CdS and Pt NPs were uniformly deposited on the surface of TiO2 nanotub...

متن کامل

Photocatalytic H2 production on trititanate nanotubes coupled with CdS and platinum nanoparticles under visible light: revisiting H2 production and material durability.

The photocatalytic production of molecular hydrogen (H2) on ternary composites of Pt, CdS, and sodium trititanate nanotubes (NaxH2-xTi3O7, TNTs) is examined in an aqueous 2-propanol (IPA) solution (typically 5 vol%) at a circum-neutral pH under visible light (λ > 420 nm). The H2 production rates are dependent on the Pt-loading level, and the optimum production rate in the Pt/CdS/TNTs is approxi...

متن کامل

Preparation and enhanced visible-light photocatalytic H2-production activity of CdS-sensitized Pt/TiO2 nanosheets with exposed (001) facets.

CdS-sensitized Pt/TiO(2) nanosheets with exposed (001) facets were prepared by hydrothermal treatment of a Ti(OC(4)H(9))(4)-HF-H(2)O mixed solution followed by photochemical reduction deposition of Pt nanoparticles (NPs) on TiO(2) nanosheets (TiO(2) NSs) and chemical bath deposition of CdS NPs on Pt/TiO(2) NSs, successively. The UV and visible-light driven photocatalytic activity of the as-prep...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008