TID Damage and Annealing Response of 90 nm Commercial-Density SRAMs
نویسنده
چکیده
We characterize the TID resilience and annealing response of high-density SRAMs, fabricated in 90 nm commercial processes. Results demonstrate intrinsic SRAM hardness at 300 krad(Si), but also reveal several orders of magnitude increase in leakage current at 1 Mrad(Si) of exposure, with recorded critical functionality failures. However, the technology is shown to be very responsive to temperature treatments as all chips recover to pre-rad leakage levels after 5 hours at 150C with fully regained functionality. Finally, consecutive exposure/anneal cycles reveal a drastic improvement in TID resilience as SRAMs that did undergo at least one postrad anneal stayed fully functional up to the strategic TID level of 2 Mrad(Si) once re-exposed. The gained resilience is attributed to negative interface trapped charge build-up along the STI walls: it progressively turns OFF the channel of parasitic transistors responsible for TID-induced leakage paths creation.
منابع مشابه
Modeling of Total Ionizing Dose Effects in Advanced Complementary Metal-Oxide-Semiconductor Technologies by
i ABSTRACT The increased use of commercial complementary metal-oxide-semiconductor (CMOS) technologies in harsh radiation environments has resulted in a new approach to radiation effects mitigation. This approach utilizes simulation to support the design of integrated circuits (ICs) to meet targeted tolerance specifications. Modeling the deleterious impact of ionizing radiation on ICs fabricate...
متن کاملMicrostructural and chemical transformation of thin Ti/Pd and TiDy/Pd bilayer films induced by vacuum annealing.
Using a combination of scanning electron microscopy, transmission electron microscopy (TEM), X-ray diffraction and X-ray photoelectron spectroscopy (XPS), we made a comparative study of the high-temperature annealing impact on thin titanium deuteride (TiD(y)) films covered by an ultrathin Pd layer, and on Ti/Pd bilayer films. The bilayer films were prepared under ultrahigh vacuum conditions and...
متن کاملThe Effect of Tin Weight Fraction and Annealing Condition on Electrical and Optical Properties of ITO/TiO2 Nanostructured Film
High transparent conductive indium tin oxide/titanium dioxide (ITO/TiO2) nanostructured thin film is prepared by sol-gel dip-coating technique. This method yielded monodisperse ITO nanoparticles with mean diameter of 12 nm. The atomic composition of the Sn within the ITO structure changed from 0-20 wt.%. Through controlled annealing temperature at 550 oC, the result...
متن کاملAn investigation on full annealing temperature and annealing twins’ Density in Fe-33Mn-3Si-2Al high-manganese steel
Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...
متن کاملRecent Radiation Test Results at JPL
This paper documents recent TID test results (including proton damage and ELDRS) obtained by JPL. Unusual test results, such as abnormally low or high failure levels or unusual failure or response mechnisms, are emphasized. W O E : In this paper summary, only a partial set of parts are listed and discussed. The final paper will list all parts tested for TID or proton damage over the past three ...
متن کامل