Assessment of Innovative Fuel Designs for High Performance
نویسندگان
چکیده
To increase the power density and maximum allowable fuel burnup in light water reactors, new fuel rod designs are investigated. Such fuel is desirable for improving the economic performance light water reactors loaded with transuranic-bearing fuel for transmutation, as well as those using UO2 fuel. A proposal for using silicon carbide duplex as fuel cladding is investigated. The cladding consists of a monolithic inner layer surrounded by a tightly wound fiber-matrix composite. The monolith layer retains the volatile fission products while the composite adds strength. The FRAPCON steady-state thermo-mechanical fuel rod modeling code is used to examine the performance of SiC cladding at high fuel burnup and high power density. Empirical models are developed to describe the physical properties of the composite as a function of operating temperature and neutron fluence. A comparison of the behavior of the SiC cladding to the conventional Zircaloy cladding demonstrates that the SiC has superior resistance to creep and mechanical degradation due to radiation or oxidation. However, the lower thermal conductivity of the SiC is a major issue, which results in significantly increased peak fuel temperatures. Mixed U0 2-PuO2 fuel is also examined in place of traditional UO2 pellets, since this may better resemble transmutation fuels of the future. It is found that the use of plutonium-bearing mixed-oxide fuels further exacerbates the high fuel temperatures. The silicon carbide cladding is predicted to have more favorable performance when used for internallyand externally-cooled annular fuel rods developed at MIT. Both sintered annular pellets and VIPAC granular fuel are examined. Because of the fuel geometry, the average fuel temperature is significantly lower, and the stiffness of the SiC cladding helps to maintain the geometry of the annulus during extended irradiation. Experimental projects have been undertaken to study the performance of both the annular fuel rods and silicon carbide duplex cladding. A post-irradiation examination of prototype annular fuel rods with VIPAC fuel, irradiated in the MIT reactor, has been designed and executed. Through this non-destructive examination, the disposition of the fuel grains is examined, and fuel burnup and fission gas release is estimated. These experimental results correlate well with computer calculations. A new irradiation facility was also planned and constructed that consists of a closed loop, operated at pressurized water reactor pressure, temperature, and chemistry conditions. This facility contains silicon carbide duplex cladding samples of various constructions, and it will be irradiated in the core of the MIT reactor for several months.
منابع مشابه
Performance assessment of a SOFC cogeneration system for residential buildings located in eastern Iran
It is expected that residential units may replace traditional heat and power production systems with cogeneration ones. Among the different cogeneration systems, fuel cell based systems are a suitable choice due to their high efficiency, high power density, low emission and low noise. In this paper, a cogeneration system based on solid oxide fuel cells is examined. The system, including the f...
متن کاملNumerical Modeling of an Innovative Bipolar Plate Design Based on the Leaf Venation Patterns for PEM Fuel Cells
Flow channel design on bipolar plates has a direct effect on Proton Exchange Membrane (PEM) fuel cell performance. It has been found out that the flow field design has a deterministic role on the mass transport and water management, and therefore on the achieved power in PEM Fuel cells. This study concentrates on improvements in the fuel cell performance through optimization of channel dimensio...
متن کاملFuel Consumption Minimization in Greenhouses by Employing an Innovative System Taking Advantage of Solar and Geothermal Energies
Replacing fossil flues by renewable and sustainable energies have been the concern of scientists working in this area over the recent decades. Furthermore, greenhouses play a key role in producing various crops year-round and in bohemian climates. For this objective, the greenhouses employ heating, ventilating and air conditioning (HVAC) systems to provide the favourable conditions for the cons...
متن کاملResearch and Assessment of Applying Dimethyl Ether “DME” Extracted from Natural Gas “Ng”, on Diesel Engine as a Clean Fuel (TECHNICAL NOTE)
Due to the shortage of liquid hydrocarbon fuels for compression ignition engines, researchers have constantly been looking for alternative fuels. Recently, dim ethyl ether (DME) with its interesting properties, such as high cetane number and low exhaust emission has drawn a lot of interst as a suitable fuel for diesel engines. The main objective of this study was to assess the potentials and fe...
متن کاملPerformance assessment of a hybrid fuel cell and micro gas turbine power system
In this paper, a hybrid solid oxide fuel cell (SOFC) and micro gas turbine (MGT) power system is parametrically studied to evaluate the effect of different operating conditions. The SOFC/MGT power system includes SOFC reactor, combustion chamber, compressor and turbine units, and two heat exchangers. The effects of fuel utilization, temperature, and pressure are assessed on performance of t...
متن کامل