Sputter Deposition of Ferrite Films and Application for High Density Rigid Disk Media in Contact Mode
نویسندگان
چکیده
Co-Zn ferrite and BaM ferrite films were deposited on silicon wafer disks with thermally oxidized surface layer without annealing process, and their readlwrite characteristics in contact mode have been investigated by using a MIG and Mn-Zn ferrite head with gap length of 0.2-0.4 pm. The highest linear recording density D50 of Co-Zn ferrite and Ba ferrite films were 105 and 190 WRPI, respectively. Clear dipulse was observed for isolated wave form of Ba ferrite disks and then dipulse ratio was 0.65. It was concluded that the Co-Zn ferrite films and Ba ferrite films have high potential as an isotropic and a perpendicular recording layer, respectively, in contact recording mode at ultra-high density
منابع مشابه
Crystallographic and Magnetic Characteristics of Ba Ferrite Sputtered Films for High Density Magnetic Recording Disks
Ba ferrite films with non-stoichiometric composition were deposited using Facing Targets Sputtering apparatus. The films with well c-axis orientation and remarkable perpendicular anisotropy were attained even at the substrate temperature below 600°C. Sufficiently large saturation magnetization 4 w o f 3.7 kGand small crystallite size below 20 nm were attained using the targets with Fe-excessive...
متن کاملBarium ferrite thin film media with perpendicular c-axis orientation and small grain size
Barium ferrite thin films with perpendicular c-axis orientation and small grain size ~about 300 Å! were successfully fabricated with careful control of sputtering conditions. The c-axis orientation of barium ferrite thin films is most sensitive to the oxygen partial pressure during deposition. All samples with oxygen gas during deposition have a random c-axis texture, as indicated by existence ...
متن کاملA NEW MATHEMATICAL MODELING OF CONTACT TREATMENT BETWEEN AN ORTHOTROPIC MATERIAL AND A RIGID INDENTER
Abstract: The boundary value problems involving contact are of the great importance in industries related to mechanical and materials engineering. These mixed problems are challenging since a priori unknown deformed surface of the material contacting a rigid indenter is to be determined as a part of the solution. Anisotropic solids represent an important class of engineering materials including...
متن کاملReview of the tribology of diamond-like carbon
Diamond-like carbon (DE) films are characterized by very low friction coefficients, high wear resistance and high corrosion resistance. Depending upon the testing environment, the coefficient of friction can be as low as 0.01. As-deposited films are wear resistant in vacuum as well as in atmospheric ambient. However, the tribological properties of DLC are strongly affected by the deposition met...
متن کاملMagnetic Thin Film Characterization
An improvement on the fabrication of magnetic thin films is currently on a level of intense research as these films are of great interest in the device industry. Some of these thin films posses high permeability and ferromagnetic resonance (FMR) frequency in the GHz range which are suitable for electromagnetic use. Methods for fabricating these films include sputtering, pulse laser deposition (...
متن کامل