A Micropower Chopper - CDS Operational Amplifier

نویسندگان

  • Massimiliano Belloni
  • Edoardo Bonizzoni
  • Andrea Fornasari
  • Franco Maloberti
چکیده

A low-power spur-free precision amplifier, which uses input chopping and correlated double sampling for demodulation, is presented. This circuit employs an AC coupling between the first and the second stage that removes the first stage offset without causing ripple. The input rail-to-rail circuit, fabricated in a mixed 0.18–0.5 m CMOS technology, operates with supply ranging from 1.8 V to 5 V. The circuit achieves a simulated 168-dB DC gain with an overall current consumption of 14.4 A. The measured offset voltage over the available samples results in a distribution with 2V standard deviation. The obtained input noise density at low-frequency equal to 37 nV Hz gives a 5.5 noise efficiency factor.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A current noise reduction technique in chopper instrumentation amplifier for high-impedance sensors

A current noise reduction technique in chopper instrumentation amplifier (CIA) for high-impedance sensor is presented. The proposed technique is based on a time gating method to reduce time varying shot noise which is induced by channel charge injection of chopper switch transistors. An implemented CIA with the proposed time gating technique achieves more than 80-% noise reduction capability.

متن کامل

A 1 V Low-Noise CMOS Amplifier Using Autozeroing and Chopper Stabilization Technique

A low-noise CMOS amplifier operating at a low supply voltage is developed using the two noise reduction techniques of autozeroing and chopper stabilization. The proposed amplifier utilizes a feedback with virtual grounded input-switches and a multiple-output switched opamp. The low-noise amplifier fabricated in a 0.18-μm CMOS technology achieved 50-nV/ √ Hz input noise at 1-MHz chopping and 0.5...

متن کامل

Dynamic Offset Cancellation Techniques for Operational Amplifiers

At low frequencies, offset, 1/f noise and drift are the dominant error sources of operational amplifiers. This is especially true in CMOS technology. This chapter reviews precision techniques that can be used to achieve low 1/f noise and low offset in operational amplifiers. There are three types of CMOS offset cancellation techniques: trimming, chopping, and auto-zeroing. Trimming is usually p...

متن کامل

A 1V Supply Low Noise CMOS Amplifier Using Noise Reduction Technique of Autozeroing and Chopper Stabilization

A low-noise CMOS amplifier operating at a 1-V supply voltage is developed using the two noise reduction techniques of autozeroing and chopper stabilization. The proposed amplifier utilizes a feedback with virtual grounded input-switches and a multiple-output switched op-amp. The low-noise amplifier fabricated by a 0.18-μm CMOS technology was measured at a 1-V power supply, and achieved low nois...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • J. Solid-State Circuits

دوره 45  شماره 

صفحات  -

تاریخ انتشار 2010