Miniaturized suspension structure for precise flying height positioning measurement using a swing arm actuator with a holographic optical element module sensor
نویسندگان
چکیده
منابع مشابه
Measuring the deposited energy from a non-ionizing laser beam in water by digital holographic interferometry
Digital Holographic interferometry is a powerful and widely used optical technique for accurate measurement of variations in physical quantities such as density, refractive index, and etc. In this study, an experimental digital holographic interferometry setup was designed and used to measure the amount of energy changes induced by absorption of radiation from a non-ionizing infrared laser beam...
متن کاملAdaptive Regulation of the Flying Height Based on Hybrid Actuator in Near-field Optical Disk Drives
In the next generation near-field optical data storage systems, higher data transfer rate and higher data density require the optical pickup head to maintain a constant sub-micrometer flying height above the rotating disk surface without any collisions. However, suspension vibration and force disturbance, as well as disk vibration make it difficult to maintain the desired flying height during d...
متن کاملEnhancement of Optical Adaptive Sensing by Using a Dual-Stage Seesaw-Swivel Actuator with a Tunable Vibration Absorber
Technological obstacles to the use of rotary-type swing arm actuators to actuate optical pickup modules in small-form-factor (SFF) disk drives stem from a hinge's skewed actuation, subsequently inducing off-axis aberrations and deteriorating optical quality. This work describes a dual-stage seesaw-swivel actuator for optical pickup actuation. A triple-layered bimorph bender made of piezoelectri...
متن کاملDynamic characterisation of the head-media interface in hard disk drives using novel sensor systems
Hard disk drives function perfectly satisfactorily when used in a stable environment, but in certain applications they are subjected to shock and vibration. During the work reported in this thesis it has been found that when typical hard disk drives are subjected lo vibration, data transfer failure is found to be significant at frequencies between 440Hz and 700Hz, at an extreme, failing at only...
متن کاملServo signal processing for flying height control in hard disk drives
A novel method of measuring the relative headmedium spacing based on a measurement in the servo sectors is developed and simulated using a read back signal model. The spacing measurement is tested experimentally on a spin stand where the flying height is varied using the resistance heater element in a thermal flying height control slider. In addition, voltage step response measurements were obt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2011