Growth directions in directionally solidified Al–Zn and Zn–Al alloys near eutectic composition

نویسندگان

  • M. Rhême
  • F. Gonzales
  • M. Rappaz
چکیده

Growth directions and crystallographic orientations of solidification microstructures have been measured in Al–Zn alloy near the eutectic composition. Al dendrites in Al–92 wt.% Zn alloy were found to grow along the h110i directions while Zn dendrites in Al– 96 and 98 wt.% Zn have h10 10i trunks. In the lamellar eutectic, a crystallographic relationship has been found between the dense plane of each phase, i.e. f111gfcck f0001ghcp, and the dense directions, i.e. h110ifcckh1 210ihcp. 2008 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effects of growth rate on the physical and mechanical properties of Sn-3.7Ag-0.9Zn eutectic alloy

Sn-3.7wt.%Ag-0.9wt.%Zn alloy was directionally solidified upward under different conditions, with different growth rates (V = 3.38 220.12 μm/s) at a constant temperature gradient (G = 4.33 K/mm) and with different temperature gradients (G = 4.33 -12.41 K/mm) at a constant growth rate (V = 11.52 μm/s) by using a Bridgman-type directional solidification furnace. The microstructure was observed to...

متن کامل

Dependence of electrical resistivity on temperature and composition of Al–Cu alloys

Different compositions of Al–Cu alloys were directionally solidified upward with constant growth rate (V>18?6 mm s) and constant temperature gradient (G>4?7 K mm) using a Bridgman type growth apparatus. The variations in electrical resistivity r with temperature for directionally solidified Al–Cu alloys were measured in the range of 3732773 K using a standard four-point probe technique. Accordi...

متن کامل

Twinned dendrite growth in binary aluminum alloys

The formation of twinned dendrites (feathery grains) in binary Al–Zn, Al–Mg, Al–Cu and Al–Ni alloys has been studied in specimens directionally solidified under identical thermal conditions, i.e. G 100 K cm , v 1 mm s , and with slight natural convection in the melt. The influence of the solute element nature and content has been found to be of less importance than previously reported since fea...

متن کامل

Influence of Growth Rate and Magnetic Field on Microstructure and Properties of Directionally Solidified Ag-Cu Eutectic Alloy

We report the influence of growth rate and external magnetic field on the eutectic lamellar spacing and properties of directionally-solidified Ag-Cu eutectic alloys. The results indicated that the relationship between the lamellar spacing of directionally-solidified Ag-Cu alloys and the growth rate matched the prediction of the Jackson-Hunt model, and the constant was 5.8 µm³/s. The increasing ...

متن کامل

Formation of equiaxed crystal structures in directionally solidified Al-Si alloys using Nb-based heterogeneous nuclei

The design of chemical compositions containing potent nuclei for the enhancement of heterogeneous nucleation in aluminium, especially cast alloys such as Al-Si alloys, is a matter of importance in order to achieve homogeneous properties in castings with complex geometries. We identified that Al3Nb/NbB2 compounds are effective heterogeneous nuclei and are successfully produced in the form of Al-...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008