An Optimal Cure Process to Minimize Residual Void and Optical Birefringence for a LED Silicone Encapsulant
نویسندگان
چکیده
Silicone resin has recently attracted great attention as a high-power Light Emitting Diode (LED) encapsulant material due to its good thermal stability and optical properties. In general, the abrupt curing reaction of the silicone resin for the LED encapsulant during the curing process induces reduction in the mechanical and optical properties of the LED product due to the generation of residual void and moisture, birefringence, and residual stress in the final formation. In order to prevent such an abrupt curing reaction, the reduction of residual void and birefringence of the silicone resin was observed through experimentation by introducing the multi-step cure processes, while the residual stress was calculated by conducting finite element analysis that coupled the heat of cure reaction and cure shrinkage. The results of experiment and analysis showed that it was during the three-step curing process that the residual void, birefringence, and residual stress reduced the most in similar tendency. Through such experimentation and finite element analysis, the study was able to confirm that the optimization of the LED encapsulant packaging process was possible.
منابع مشابه
Optimization of thermal curing cycle for a large epoxy model
Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...
متن کاملTransfer Molding Encapsulation of Flip Chip Array Packages
Epoxy molding compounds have been developed which can simultaneously underfill and overmold the Flip Chip die in a single transfer molding process. Transfer molding is a well-defined industry process; with suitable mold design, these materials can utilize the currently installed capital base. The ability to apply pressure during the molding process can reduce the void rate under the die as well...
متن کاملEffects of the refractive index of the encapsulant on the light-extraction efficiency of light-emitting diodes.
We investigate the effects of the refractive index of the encapsulant on the light-extraction efficiency (LEE) of light-emitting diodes (LEDs) for GaN LEDs (n ≈ 2.5) and AlGaInP LEDs (n ≈ 3.0). For non-absorbing rectangular parallelepiped LED chips, as the refractive index of the encapsulant increases, the LEE first increases quasi-linearly, then increases sub-linearly, and finally a saturation...
متن کاملHigh performance encapsulant for light-emitting diodes (LEDs) by a sol–gel derived hydrogen siloxane hybrid
The hydrosilylation reaction is a dominant curing method for the light-emitting diode (LED) silicone encapsulant, which requires characteristics of high transparency, high refractive index, and thermal stability against the LED junction temperature. In this research, we synthesized a hydrogen containing oligosiloxane resin through non-hydrolytic sol–gel condensation. Methyldiethoxysilane (MDES)...
متن کاملUncertainty of the Sagnac interferometer-based measurement of the modal birefringence of polarization maintaining optical fibers
Presented is an analysis of the expanded uncertainty of an indirect measurement of modal birefringence of polarization maintaining fibers, based on the Sagnac interferometer and an optical spectrum analyzer. By using this method it is easy to achieve an expanded measurement uncertainty considerably lower than 1%, at a confidence level of 0.95, in measurements of fibers, whose birefringence is i...
متن کامل