Use of Automatic Target Recognition System for the Displacement Measurements in a Small Diameter Tunnel Ahead of the Face of the Motorway Tunnel During Excavation
نویسندگان
چکیده
During construction of the Šentvid tunnel a unique opportunity arose to measure the 3D displacements ahead of the motorway tunnel excavation face, since the exploratory tunnel was already constructed in the axis of the main tunnel. According to reviewed literature such measurements had not been performed yet and several problems regarding equipment and complete scheme of the experiment needed to be overcome. The paper gives a brief description of the Šentvid tunnel project, presents significant factors that affected the choice of the geodetic equipment and describes the scheme of the experiment. A special attention is focused on the problems relating to the operation of the instrument in demanding environmental conditions (water, dust).
منابع مشابه
Cross Section Effects on Convergence-Confinement Method in Multi Stage Tunnel Excavation
Dimensionless coefficient () in convergence confinement method shows the relaxation of stress in the wall of the tunnel at different excavation movements. This factor is considered a constant number in previous studies and tunnel geometric characteristics (such as depth, cross-section shape, radius, soil material, etc.) are not included in its determination; however, ignoring these effects can...
متن کاملNumerical modeling of tunneling induced ground deformation and its control
Tunnelling through cities underlain by soft soil, commonly associated with soil movement around the tunnels and subsequent surface settlement. The predication of ground movement during the tunnelling and optimum support pressure could be based on analytical, empirical or the numerical methods. The commonly used Earth pressure balance (EPB) tunneling machines, uses the excavated soil in a pressu...
متن کاملThe use of analytic hierarchy process in the selection of suitable excavation machine for Dez - Qomroud water conveyance tunnel (lot 1&2), Iran
Qomroud water conveyance tunnel (lot 1&2) with the length of 16 kilometers is considered as one of the greatest development and national projects in Iran. Since about 2 kilometers of tunnel pass through alluvium and the rest of the tunnel pass through various types of geological units, and due to the complexity of geological condition and variety of effective criteria, suitable selection of exc...
متن کاملOn the selection of an appropriate excavation pattern for urban tunnels with big cross-section: A case study
Among various practical measures used for restriction of the ground surface settlement in such tunnels driven in soft ground, selection of an appropriate excavation method plays a significant role. In this paper, employing suggested diagram by Yu & Chern, corresponding values of Niayesh tunnel has been inserted into the diagram. Later, two excavation methods namely: central diaphragm and side d...
متن کاملPredicting three-dimensional displacement around the tunnel and its impact on the value of Q-system
Having knowledge of stability of an underground space depends on stresses and strains around it. Creating underground tunnels leads to significant changes in the rock mass stress. Therefore, to achieve the necessary stability, stresses and deformations around the tunnel must be examined carefully. Usually, stress-strain behavior analysis is conducted in two-dimensional mode. This paper was cond...
متن کامل