In vitro wear of microfilled and visible light-cured composites.
نویسندگان
چکیده
Wear of microfilled composites, a visible light-cured composite, and a conventional composite were characterized by two-body abrasion and single-pass sliding. There were differences in abrasion rates among the materials. Tangential forces, wear track widths, and surface failure modes were different among materials. Wear characteristics are combinations of these properties.
منابع مشابه
بررسی اثر نوع فیلر بر سایش سه جزئی کامپوزیت دندانی
Statement of Problem: The relatively poor wear resistance of dental composite in stress bearing posterior situations has restricted wider clinical application of this restorative material. Purpose: The aim of this study was to evaluate the three body abrasive wear of a dental composite based on a new filler (leucite: KAl Si2O6) and to compare it with the wear resistance of a composite based on ...
متن کاملBiocompatibility test of light-cured composites in vitro.
The in vitro cytctoxicity to HeLa S3 cells of set specimens of five commercially available light-cured composites was examined by the cell colony-forming method for 6 weeks. Both visible and ultraviolet light-cured composites showed moderate to strong cytotoxicity in the early stage of the experiment, followed by rapid disappearance of cytotoxicity. The light-cured composites showed in vitro bi...
متن کاملاثر جهت نوردهی بر ریزنشت دو نوع کامپازیت مایکروفیلد و هایبرید
Introduction: One of the most important factors affecting the marginal seal of composite restorations is polymerization shrinkage. The aim of this study was to evaluate the micro leakage of two resin composites cured with two light directions. Methods: In this experimental study, forty similar class III preparations were prepared in 40 human anterior teeth. The teeth were randomly divided in t...
متن کاملTwo-body wear of dental restorative materials.
AIM The aim of this in vitro study was to determine the two-body wear resistance of modern direct dental restorative materials. METHODS Eight standardized specimens were prepared from 14 dental restorative materials (nano-, micro-, hybrid-, macrofilled composites; compomer, silorane, ormocer); a veneering composite (Sinfony) and enamel were used for reference. Vickers hardness (HV) and inorga...
متن کاملWear test of composite restorative materials by a polishing machine.
The wear resistance of microfilled and conventional composite resins, was examined, using two sizes of abrasive particles for polishing. The mechanical properties of the composite resins were also studied and evaluated in relation to wear. Conventional composites showed much lower wear resistance than the microfilled resins. The amalgam and human enamel abraded with 10ƒÊm SiC particles, had str...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of dental research
دوره 58 11 شماره
صفحات -
تاریخ انتشار 1979