Digital Control in Power Electronics
نویسندگان
چکیده
منابع مشابه
Optimized Digital Optical Switch Using Proton Exchanged Lithium Niobate Waveguides
The main emphasis in developing DOS has been on achieving low crosstalk (CT). CT in the order of -30 dB is acceptable in conventional DOS and below that value is hard to achieve. Relatively low drive voltage (or power requirements) is also necessary to optimized DOS. This paper depicts the design of Y-branched digital optical switches (DOS) with optimized on-chip area coverage, reduced driving ...
متن کاملFPGA Implementation of a Hammerstein Based Digital Predistorter for Linearizing RF Power Amplifiers with Memory Effects
Power amplifiers (PAs) are inherently nonlinear elements and digital predistortion is a highly cost-effective approach to linearize them. Although most existing architectures assume that the PA has a memoryless nonlinearity, memory effects of the PAs in many applications ,such as wideband code-division multiple access (WCDMA) or orthogonal frequency-division multiplexing (OFDM), can no longer b...
متن کاملUsing Logisim Digital Circuit Simulator for Examining Power Electronics Digital Control Systems
Logisim is a program used for digital circuits simulation – gates, flip-flops and latches. This paper presents a simple method, which allows simulation of circuits, designed for the power electronics devices, based on digital control units.
متن کاملA Coordinated Control Scheme for Improving Voltage Quality Using Power Electronics Interfaced DGs
Recently, increasing of non-linear loads in the power distribution network has been increased harmonics in these networks. The harmonics problems get worse and complicated by installation of power factor correction capacitors and filters. But the Distributed Generations (DGs) interface inverters with properly control can help to improve power quality, harmonic compensation and voltage unbalance...
متن کاملThe Effectiveness of Dynamic Voltage Restorer with the Distribution Networks for Voltage Sag Compensation
This paper discusses the Dynamic voltage restorer (DVR) operation and control for Voltage sags compensation. DVR is a series connected power electronic based device that can quickly mitigate the voltage sags in the system and restore the load voltage to the pre-fault value. Voltage sag associated with faults in transmission and distribution systems, energizing of transformers, and starting of l...
متن کامل