A road damage and life-cycle greenhouse gas comparison of trucking and pipeline water delivery systems for hydraulically fractured oil and gas field development in Colorado

نویسندگان

  • Ray C Duthu
  • Thomas H Bradley
چکیده

The process of hydraulic fracturing for recovery of oil and natural gas uses large amounts of fresh water and produces a comparable amount of wastewater, much of which is typically transported by truck. Truck transport of water is an expensive and energy-intensive process with significant external costs including roads damages, and pollution. The integrated development plan (IDP) is the industry nomenclature for an integrated oil and gas infrastructure system incorporating pipeline-based transport of water and wastewater, centralized water treatment, and high rates of wastewater recycling. These IDP have been proposed as an alternative to truck transport systems so as to mitigate many of the economic and environmental problems associated with natural gas production, but the economic and environmental performance of these systems have not been analyzed to date. This study presents a quantification of lifecycle greenhouse gas (GHG) emissions and road damages of a generic oil and gas field, and of an oil and gas development sited in the Denver-Julesburg basin in the northern Colorado region of the US. Results demonstrate that a reduction in economic and environmental externalities can be derived from the development of these IDP-based pipeline water transportation systems. IDPs have marginal utility in reducing GHG emissions and road damage when they are used to replace in-field water transport, but can reduce GHG emissions and road damage by factors of as much as 6 and 7 respectively, when used to replace fresh water transport and waste-disposal routes for exemplar Northern Colorado oil and gas fields.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Critical Parameters Affecting Water Alternating Gas (WAG) Injection in an Iranian Fractured Reservoir

Microscopic oil displacement of water flooding and sweep efficiency of continuous gas injection could be improved by water alternating gas (WAG) injection. The WAG injection process aims to squeeze more oil out of the reservoirs; in this method, water and gas are alternatively injected into the reservoir. Also, availability of hydrocarbon or CO2 gases in the field makes it attractive for gas-ba...

متن کامل

Power Consumption Minimization of Khormoj Compressor Station

Arguably, the natural gas transmission pipeline infrastructure in Iran represents one of the largest and most complex mechanical systems in the world. The optimization of large gas trunk lines known as IGAT results in reduced fuel consumption or higher capability and improves pipeline operation. In the current study, a single-objective optimization was conducted for Khormoj compressor station o...

متن کامل

Investigation of Slug Suppression System in Deepwater Scenario

In pipeline-riser systems, pressure fluctuations which result from the formation of large liquid slugs and gas surges due to operational changes or low mass flow rate from production wells and the profile of pipeline-riser systems often lead to trips at the inlet of the separator; and thereby, the problem causes a a loss of the production.In this study, on a sample deep-water oil field off the ...

متن کامل

Comparison of energy consumption and greenhouse gas emission footprint caused by agricultural products in greenhouses and open field in Iran

Decisions can be taken to increase energy efficiency and to mitigate the emissions to the environment by examining the energy audit and greenhouse gas (GHG) emissions footprint of crop production in different ways and in different regions, with comparable principles. In this study, energy consumption and energy indices of tomatoes production in four regions of Iran including East Azerbaijan...

متن کامل

UTILIZING CONCEPTUAL MODELING IN THE STUDY OF ONE OF THE IRANIAN FRACTURED CARBONATE RESERVOIRS

A typical Iranian carbonate matrix block surrounded by an open fracture was modeled in order to understand the fracture-matrix interaction and realize how to model the interaction best. The modeling was carried out by using a fine-scaled Eclipse model in the single porosity mode (the fractures were explicitly modeled). The model was extended to a stack of 6 matrix blocks to understand block-to-...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 12  شماره 

صفحات  -

تاریخ انتشار 2017