An investigation of mechanical behaviour of resin with varying parameters of curing

نویسندگان

  • Piyush S. Jain
  • A. A. Shaikh
چکیده

In this paper, mechanical behavior of polyester with varying parameters of curing were investigated. Binder content, accelerator content, temperature and time were ascertained as parameters during curing of polyester specimens. Three levels of each parameter were selected and taguchi techniques are implemented. It was observed that curing time and binder content influenced mechanical properties of resin while variation in temperature and accelerator content had not affected properties considerably.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Optimization of thermal curing cycle for a large epoxy model

Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...

متن کامل

Numerical Prediction of Temperature Distribution in Transient RTM Process

Resin Transfer Molding (RTM) is a composite manufacturing process. A preformed fiber is placed in a closed mold and a viscous resin is injected into the mold. In this paper, a model is developed to predict the flow pattern, extent of reaction and temperature change during filling and curing in a thin rectangular mold. A numerical simulation is presented to predict the free surface and...

متن کامل

Investigation of Parameters Effect Resin Movement Velocity at Vacuum Assisted Resin Transfer Molding Method (VARTM)

In this paper, Vacuum Assisted Resin Transfer Molding (VARTM) method was simulated by analytical solution. Then the effect of parameters like fiber density, distribution of layer thickness, perform layer thickness, resin viscosity was investigated theoretically. Obtained results show that by selecting optimum distribution layer thickness, increasing fiber volume fraction, reducing viscosity of ...

متن کامل

Investigation of Parameters Effect Resin Movement Velocity at Vacuum Assisted Resin Transfer Molding Method (VARTM)

In this paper, Vacuum Assisted Resin Transfer Molding (VARTM) method was simulated by analytical solution. Then the effect of parameters like fiber density, distribution of layer thickness, perform layer thickness, resin viscosity was investigated theoretically. Obtained results show that by selecting optimum distribution layer thickness, increasing fiber volume fraction, reducing viscosity of ...

متن کامل

Numerical Modeling of Mold Filling and Curing in Non-Isothermal RTM Process (RESEARCH NOTE)

Resin Transfer Molding (RTM) is a composite manufacturing process. A preformed fiber is placed in a closed mold and a viscous resin is injected into the mold. In this paper, a model is developed to predict the flow pattern, extent of reaction and temperature change during filling and curing in a thin rectangular mold. A numerical simulation is presented to predict the free surface and its inter...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012