Treatment of Bisphenol A-Containing Effluents from Aerobic Granular Sludge Reactors with the Use of Microfiltration and Ultrafiltration Ceramic Membranes

This study investigated the use of ceramic membranes to remove total suspended solids (TSS), organics (expressed by chemical oxygen demand, COD), and bisphenol A (BPA) via microfiltration (MF, pore size 0.45 μm) and ultrafiltration (UF, cutoff 150 kDa) in post-treatment of effluents from aerobic granular sludge reactors (GSBRs). The efficiency of removal of COD, BPA, and TSS in MF was similar to that in UF; however, it was achieved at a lower pressure, which reduces energy consumption during the filtration process. Despite the similar quality of the permeates in MF and UF, the permeate flux averaged almost 20% higher in UF than in MF. The rejection coefficients were 77-82% for COD and 48-100% for BPA. In both MF and UF, TSS were totally removed. In the integrated system of aerobic granular sludge reactor and membrane installation, total removal of COD was 92-95% and that of BPA was above 98%, independently of the membrane technique. The high efficiency of BPA removal in MF and UF, despite pore sizes in the MF and UF membranes larger than the BPA molecules, suggests that some part of the BPA was first bound by particulate organic matter in the biologically treated wastewater before this sorbed form was removed by the membranes. Furthermore, the high removal of COD and BPA, even in MF, was attributed to adsorption on the membranes, in addition to sieve retention.