Upconversion based continuous-wave mid-infrared detection
نویسندگان
چکیده
We present theoretical and experimental work on upconversion based mid-wavelength infrared detection using silicon detectors without the need for cryogenic cooling. We consider both multi-spectral imaging and point spectroscopy targeting several specific applications. OCIS codes: (190.7220) Upconversion; (300.6340) Spectroscopy, infrared; (100.2960) Image analysis;
منابع مشابه
Low-noise mid-IR upconversion detector for improved IR-degenerate four-wave mixing gas sensing.
We compare a nonlinear upconversion detector with a conventional cryogenic InSb detector for the detection of coherent infrared light showing near-shot-noise-limited performance in the upconversion system. The InSb detector is limited by dark noise, which results in a 500 times lower signal-to-noise ratio. The two detectors are compared for the detection of a coherent degenerate four-wave mixin...
متن کاملInfrared hyperspectral upconversion imaging using spatial object translation.
In this paper hyperspectral imaging in the mid-infrared wavelength region is realised using nonlinear frequency upconversion. The infrared light is converted to the near-infrared region for detection with a Si-based CCD camera. The object is translated in a predefined grid by motorized actuators and an image is recorded for each position. A sequence of such images is post-processed into a serie...
متن کاملPeriodically poled lithium niobate waveguide sum-frequency generator for efficient single-photon detection at communication wavelengths.
We present a device to facilitate single-photon detection at communication wavelengths based on continuous-wave sum-frequency generation with an upconversion efficiency exceeding 90%. Sum-frequency generation in a periodically poled lithium niobate waveguide is used to upconvert signal photons to the near infrared, where detection can be performed efficiently by use of silicon avalanche photodi...
متن کاملTime-domain upconversion measurements of group-velocity dispersion in quantum cascade lasers.
A time-resolved mid-infrared upconversion technique based on sum-frequency generation was applied to measure pulse propagation in lambda approximately 5.0 mum quantum cascade lasers operated in continuous wave at 30 K. The wavelength-dependent propagation delay of femtosecond mid-infrared pulses was measured to determine the total group-velocity dispersion. The material and waveguide dispersion...
متن کاملEnhanced 2D-image upconversion using solid-state lasers.
Based on enhanced upconversion, we demonstrate a highly efficient method for converting a full image from one part of the electromagnetic spectrum into a new desired wavelength region. By illuminating a metal transmission mask with a 765 nm Gaussian beam to create an image and subsequently focusing the image inside a nonlinear PPKTP crystal located in the high intra-cavity field of a 1342 nm so...
متن کامل