Design and Manufacture of a Capacitance Probe for Hole Metrology
نویسندگان
چکیده
منابع مشابه
Monte Carlo-based optimization of a gamma probe system for sentinel lymph node mapping
Introduction: Sentinel lymph node biopsy (SLNB) is a standard surgical technique to identify sentinel lymph node (SLN) for the staging of early breast cancer. Nowadays, two methods are used for the identification of SLN: blue dye method aiding visually and radioactive dye using gamma detector. A wide range of gamma probe systems with different design and performance are used in...
متن کاملDesign and Evaluation of a Prototype Instrument for Measuring Roundness Profiles of Micro Shafts
INTRODUCTION This paper describes the design and some initial evaluation of a prototype instrument for measuring roundness profiles of axially symmetric micro components with diameters below 500 μm. The instrument will measure form error in micro-scale cutting tools used for micro machining, small-hole metrology probes, and other high aspect ratio micro structures. The instrument will operate o...
متن کاملDesign and Construction of a Sensitive Capasitive Sensor System (RESEARCH NOTE)
Design and construction of a capacitor sensor with a precise readout system are described in this paper. A variable air-gap capacitive transducer was constructed and for signalmeasurement a successful attempt was made to exploit the capacitance changes in terms of the phase angle of the detected signal. The reported setup makes it possible to detect capacitance changes of the order of 2.5 fF in...
متن کاملIndoor GPS Metrology System with 3D Probe for Precision Applications
There is an increasing demand from industry for intelligent reverse engineering solutions. The requirement is to be able to perform reverse engineering, to create CAD models, or to compare prototypes with CAD models. A reverse engineering solution that can be used for 6 degrees of freedom pose measurement in a large area is desired. With this application in mind, we have developed a ‘3D Probe’ ...
متن کاملScanning impedance microscopy (SIM): A novel approach for AC transport imaging
Scanning Impedance Microscopy (SIM) is one of the novel scanning probe microscopy (SPM) techniques, which has been developed to taking image from sample surface, providing quantitative information with high lateral resolution on the interface capacitance, and investigating the local capacitance–voltage (C–V) behavior of the interface and AC transport properties. The SIM is an ordinary AFM equip...
متن کامل