Fabrication, Treatment and Testing of a 1.6 Cell Photo- Injector Cavity for Hzb*

As an amendment to a CRADA (Cooperative Research and Development Agreement) between Forschungszentrum Dresden (FZD) and JLab we have fabricated and tested after appropriate surface treatment a 1.6 cell, 1300 MHz RRR niobium photo-injector cavity to be used in a demonstration test at HZB. Following a baseline test at JLab, the cavity received a lead spot coating of ~8 mm diameter deposited with a cathode arc at the Soltan Institute on the endplate made from large grain niobium. It had been demonstrated in earlier tests with a DESY built 1.6 cell cavity – the original design – that a lead spot of this size can be a good electron source, when irradiated with a laser light of 213 nm. In the initial test with the lead spot we could measure a peak surface electric field of ~29 MV/m; after a second surface treatment, carried out to improve the cavity performance, but which was not done with sufficient precaution, the lead spot was destroyed and the cavity had to be coated a second time. This contribution reports about the experiences and results obtained with this cavity.