Lateral Force Microscopy Study of the Friction between Silica Surfaces.

نویسندگان

  • Biggs
  • Cain
  • Page
چکیده

The friction between a single silica glass sphere and a flat silica glass surface has been investigated using lateral force microscopy. Two types of silica surface were investigated, one fully hydroxylated and the other partially dehydroxlated. These samples have markedly different wetting properties and are known as hydrophilic and hydrophobic silica, respectively. The lateral friction force as a function of applied normal load has been collected for five different-sized spheres for both surface types. Analysis of the friction versus load data indicates that the hydrophilic surfaces have a molecularly smooth contact. For the hydrophobic surfaces, it is not clear whether the friction-load response is caused by a smooth or an asperity-dominated contact zone. Copyright 2000 Academic Press.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Silica nano-particle super-hydrophobic surfaces: the effects of surface morphology and trapped air pockets on hydrodynamic drainage forces.

We used atomic force microscopy to study dynamic forces between a rigid silica sphere (radius approximately 45 microm) and a silica nano-particle super-hydrophobic surface (SNP-SHS) in aqueous electrolyte, in the presence and absence of surfactant. Characterization of the SNP-SHS surface in air showed a surface roughness of up to two microns. When in contact with an aqueous phase, the SNP-SHS t...

متن کامل

Microscopic Friction Studies on Metal Surfaces

Atomically flat and clean metal surfaces exhibit a regime of ultra-low friction at low normal loads. Atomic force microscopy, performed in ultra-high vacuum on Cu(100) and Au(111) surfaces, reveals a clear stick-slip modulation in the lateral force but almost zero dissipation. Significant friction is observed only for higher loads (*4– 6 nN above the pull-off force) together with the onset of w...

متن کامل

Near surface properties of mixtures of propylammonium nitrate with n-alkanols 2. Nanotribology and fluid dynamics.

Colloid probe friction force microscopy (FFM) has been used to study the lubricity of propylammonium nitrate (PAN) mixed with n-alkanols confined between sliding silica and mica surfaces. Mixtures of PAN with butanol, hexanol, octanol and dodecanol were investigated for various n-alkanol volume fractions to elucidate the effect of n-alkanol hydrocarbon chain length and concentration on shear fo...

متن کامل

Non-contact Friction Force Microscopy Exploiting Lateral Resonance Enhancement

A method for sensing the dissipation occurring when a sharp atomic force microscopy (AFM) tip is oscillated laterally above a surface at distances typical of non-contact mode AFM operation is established and demonstrated. Dissipation is detected by measuring the damping of lateral resonant modes of the AFM cantilever, excited independently after the lateral resonant mode identification, when th...

متن کامل

Sustained frictional instabilities on nanodomed surfaces: stick-slip amplitude coefficient.

Understanding the frictional properties of nanostructured surfaces is important because of their increasing application in modern miniaturized devices. In this work, lateral force microscopy was used to study the frictional properties between an AFM nanotip and surfaces bearing well-defined nanodomes comprising densely packed prolate spheroids, of diameters ranging from tens to hundreds of nano...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of colloid and interface science

دوره 232 1  شماره 

صفحات  -

تاریخ انتشار 2000