Fine control of L10 ordering and grain growth kinetics by C doping in FePt films
نویسندگان
چکیده
We present the results on highly anisotropic oriented face-centered-tetragonal ordered equiatomic FePt thin films embedded in a C matrix prepared by cosputtering technique on MgO ~100! substrates at 400 °C. We have found that doping of C in FePt alloy films is an effective and appropriate way to control the L10 ordering and growth of grain size down to 4 nm. Room-temperature magnetic measurements reveal that perpendicular magnetic anisotropy exists for these films with C concentration up to 25 vol %. These films are very promising and the results are of relevance for ultrahigh-density magnetic recording media. © 2003 American Institute of Physics. @DOI: 10.1063/1.1564865#
منابع مشابه
L 10 ordering and microstructure of FePt thin films with Cu , Ag , and Au additive
The influence of Cu, Ag, and Au additives on the L10 ordering, texture, and grain size of FePt thin films has been examined. Lattice parameter data indicated that Au and Ag additives tended to segregate from FePt, but Cu alloyed with FePt. FePt films with Au or Ag additive showed 1–2 kOe higher coercivity values compared to a pure FePt film after annealing at 450 °C and above for 10 min. The ad...
متن کاملControlling the crystallographic orientation and easy axis of magnetic anisotropy in L10 FePt films with Cu additive
By co-sputtering Cu and FePt onto Cr90Mo10 underlayers, the preferred orientation and easy axis of magnetic anisotropy of FePt films were successfully changed from the perpendicular to the in-plane direction. The pure FePt film grown on the Cr90Mo10 underlayer showed a (001) preferred orientation with out-of-plane magnetic anisotropy. As 20 and 40 vol.% Cu were doped, the FePt films showed a (2...
متن کاملEffect of lattice mismatch on chemical ordering of epitaxial L10 FePt films
The effect of lattice mismatch on the chemical ordering of epitaxial FePt films was studied. The results showed that the lattice constant scd of the FePt films decreased with increasing lattice mismatch « from about 2.23% to 6.33%. Upon further increase of « to about 8.8%, c increased. On the other hand, the variation of the lattice constant sad of the FePt films showed a reversal behavior to t...
متن کاملIn Situ Ordering of FePt Thin Films by Using Ag / Si and Ag / Mn 3 Si / Ag / Si Templates
In situ ordering of FePt thin films by sputtering onto Ag/Si and Ag/Mn3Si/Ag/Si templates has been demonstrated. Due to the evolution from island-like to a continuous film structure as a function of Ag thickness, the ordering and orientation of the FePt films both change with Ag thickness. A continuous (002) Ag film results in a greater L10 phase formation with -axis oriented both perpendicular...
متن کاملImprovement of Magnetic Properties and Texture of FePt Thin Films on MgO Substrates by Sn Addition
In this work, we studied the effects of Sn addition on the ordering temperature of FePt thin film. The coercivity of FePtSn film was about 1000 Oe greater than the coercivity of FePt film for an annealing temperature of 600C. Therefore, Sn addition was effective in promoting the L10 ordering and in reducing the ordering temperature of the FePt film. From our X-ray diffraction results, we found ...
متن کامل