Laboratory Study of the Shear Behaviour of Natural Rough Rock Joints Infilled by Different Soils
نویسنده
چکیده
Natural rock joints infilled with soil materials may show a reduced shear strength, which influences rock mass stability. The aim of this paper is to experimentally investigate the shear behaviour of infilled rock joints, taking into account joint surface characteristics and the properties of the joint and infill materials. A new model for predicting the shear strength of infilled joints is presented, on the basis of a series of tests carried out on natural rock joints with same surface roughness, with clay, sand and sandy-clay used as infill materials. All tests were carried out in a shear box apparatus under constant normal load (CNL) conditions. The empirical model was finally validated based on the experimental data from the literature. The results showed an acceptable confidence level for the model and reported that the new model successfully describes the observed shear behaviour of natural infilled rock joints.
منابع مشابه
Shear Strength of Rock Joints Based on Quantified Surface Description
One of the primary objectives of this work is to better understand the frictional behavior of joints under shear loads, including the creation of damage zones. Discontinuities have an important influence on the deformational behavior of rock systems. The choice of a general criterion to determine the shear strength of rough rock joints is a general problem that has been investigated for many ye...
متن کاملThe Validity Assessment of Laboratory Shear Modulus Using In-Situ Seismic Piezocone Test Results
Seismic piezocone device (SCPTu) together with Resonant Column and Cyclic Triaxial test apparatus are employed to measure small strain shear modulus (G0) of carbonate sandy and clayey soils of southern coasts of Iran. A large area of southern regions of Iran is formed from clay, silt and sand. In this study, maximum shear modulus that is derived from both field (by seismic piezocone) and labora...
متن کاملNEW OPTIMIZED EQUATIONS WITH INTELLIGENT MODELS FOR PREDICTING HYDRAULIC JUMP CHARACTERISTICS OVER ARTIFICIAL AND NATURAL ROUGH BEDS
The available studies for estimating the characteristics of hydraulic jump are only for artificial or natural beds, and very limited researches have simultaneously considered artificial and natural beds. The aim of this study is to present comprehensive equations and models for predicting the characteristics of hydraulic jump in artificial and natural rough beds with various dimensions, arrange...
متن کاملDeformational Characteristics of Rocks Containing a Single Discontinuity (TECHNICAL NOTE)
For the purpose of exploring deformation characteristics of jointed rock masses, influence of joint inclination and confining pressure on the mechanical behavior of discontinuous rock a series of compression tests were conducted under satisfactory testing conditions on three types of sandstone from various locations. Three groups of jointed specimens were used in this research, including specim...
متن کامل