InP-based two-dimensional photonic crystals filled with polymers
نویسنده
چکیده
Polymer filling of the air holes of Indium Phosphide based two-dimensional photonic crystals is reported. After infiltration of the holes with a liquid monomer and solidification of the infill in situ by thermal polymerization, complete filling is proven using scanning electron microscopy. Optical transmission measurements of a filled photonic crystal structure exhibit a redshift of the air band, confirming the complete filling. a Electronic mail: [email protected] b Also at: Kavli Institute of Nanoscience Delft
منابع مشابه
Fabrication of 2-D photonic crystals using azo polymers
In this paper, we have reported the fabrication of two-dimensional photonic crystals, using a direct writing method in azo polymers. Periodic structures have been fabricated using the interference patterns of two coherent laser beams. The frequency response of the initial one-dimensional structure shows an attenuation of 19.3dB at 1554nm. The twodimensional structure shows 8.3dB and 11.3dB of a...
متن کاملDesign of Photonic Crystal Polarization Splitter on InP Substrate
In this article, we suggested a novel design of polarization splitter based on coupler waveguide on InP substrate at 1.55mm wavelength. Photonic crystal structure is consisted of two dimensional (2D) air holes embedded in InP/InGaAsP material with an effective refractive index of 3.2634 which is arranged in a hexagonal lattice. The photonic band gap (PBG) of this structure is determined using t...
متن کاملDesign and Analysis of a Novel Hexagonal Shaped Channel Drop Filter Based on Two-Dimensional Photonic Crystals
In this paper a new optical channel drop filter (CDF) based on two dimensional (2-D) photonic crystals (PhC) with hexagonal shaped structure is proposed and numerically demonstrated by using the finite-difference-time-domain (FDTD) and plane-wave-expansion (PWE) techniques. Photonic crystals (PhCs) are artificial dielectric nanostructure materials in which a periodic modulation of the material ...
متن کاملمقایسه نتایج شبیهسازی بلور فوتونی با استفاده از روش FDTD دوبعدی بهبودیافته و FDTD سهبعدی
The accuracy of improved two dimensional finite difference time domain method (2D FDTD) is verified by comparing with 3D FDTD method and experimental data. The optimized 60° photonic crystal waveguide bend, used in this study as a test case, is composed of InPGaAs/InP material and air holes and TE polarization is considered. The photonic crystal waveguide bend transmission data was measured...
متن کاملبررسی موجبر جداکننده توان بهینه بلور فوتونیک
We investigate the transmission behavior of photonic crystals power splitter by using improved 2D FDTD and MMP methods. The Comparison between experimental data and simulation results are discussed in TE polarization. In this study, the 60° photonic crystal power splitter is optimized, which is composed of InPGaAs/InP material and air holes. The photonic crystal waveguide bend transmission ...
متن کامل