Interpreting Antenna Performance Parameters for EMC Applications: Part 3: Antenna Factor
نویسندگان
چکیده
This article is the third in a three-part tutorial series covering antenna terminology. As noted, our intention is to discuss standardized antenna terminology as published in the IEEE Standard Definitions of Terms for Antennas, and how this terminology compares with the nomenclature that is commonly used in the EMC community. In the first part of this series, we discussed radiation efficiency and input impedance match. In the second part of this series, we discussed antenna field regions and antenna gain, and in this part we will discuss antenna factor and its importance to EMC measurements.
منابع مشابه
Ultra Wideband Monopole Antenna Excited by a Capacitive Coupling Feed with Double Band Notch Function
This paper presents the results of a new monopole antenna that exhibits 2.75-10.7 GHz performance. The proposed antenna consists of a radiating patch with notches excited by capacitive coupling feed. Also, the antennas truncated ground-plane incorporates a central notch. This modification significantly improves the antennas impedance bandwidth by 118% over an ultra-wideband frequency range. T...
متن کاملA Capacitive Fed Microstrip Patch Antenna with Air Gap for Wideband Applications (RESEARCH NOTE)
In this paper a microstrip antenna on a suspended substrate with capacitive feed is presented. capacitive feed is created by a slot within the rectangular patch around the feed point. The proposed antenna exhibits a much higher impedance bandwidth of about 47% (S11 < −10 dB). Effects of key design parameters such as the air gap between the substrate and the ground plane, the gap width between r...
متن کاملModified Rectangular Patch Antenna Loaded With Multiple C Slots for Multiple Applications
A new multiple C-slotted microstrip patch antenna is proposed in the present study. A patch antenna is a wide-beam narrowband antenna. The microstrip patch antenna consists of a very thin metallic strip (patch) placed a small fraction of a wavelength above a ground plane. The patch can be designed in any possible shape and normally made of conducting materials such as copper or gold. This study...
متن کاملNumerical Modeling and Experimental Study of Probe-Fed Rectangular Dielectric Resonator Antenna (RDRA) Supported by Finite Circular Ground Plane
Dielectric Resonator Antennas (DRAs) have received increased interest in recent years for their potential applications in microwave and millimeter wave communication systems. DRAs are normally used with the support of a ground plane. The radiation and impedance properties therefore depend not only on their physical dimensions and dielectric properties, but also on the size of the ground plane. ...
متن کاملNew Low Cost Printed Antenna CPW-Fed for Global Positioning System, Personal Communication System and Worldwide Interoperability for Microwave Access Band Applications (TECHNICAL NOTE)
This paper presents a new design of a CPW-Fed multi bands planar antenna. This antenna can be integrated easily with passive and active elements. The proposed antenna is suitable to operate for GPS, PCS and WiMAX bands. Its entire area is 52.3x52.6mm2 and is employed on an FR-4 epoxy substrate and fed by a 50 Ohm coplanar line. The antenna parameters have been analyzed and optimized by using AD...
متن کامل