Design of a Four-Rotor Aerial Robot
نویسنده
چکیده
The design and fabrication of a prototype four-rotor vertical take-off and landing (VTOL) aerial robot for use as indoor experimental robotics platform is presented. The flyer is termed an X4-flyer. A development of the dynamic model of the system is presented and a pilot augmentation control design is proposed.
منابع مشابه
Designing and implementation of an unmanned aerial vehicle for inspection of electricity distribution networks
One of the most crucial elements of each country is electricity distribution networks (EDN). Awareness of accidents in EDN could be very important in the conservation and utilization of them. The accurate and periodic inspections can provide a good service to subscribers. The goal of this project is to fabricate a quad rotor, which can do an accurate and a periodic inspection. The design and im...
متن کاملTowards Dynamically-Favourable Quad-Rotor Aerial Robots
This paper outlines progress towards realising practical quad-rotor robot helicopters and, in particular, the Australian National University’s ‘X-4 Flyer’ platform. Two challenges facing the X-4 are generating sufficient thrust and managing unstable dynamic behaviour. We address these issues with a rotor design technique for maximising thrust and the application of a novel rotor mast configurat...
متن کاملRobust Control of a Quadrotor in the Presence of Actuators' Failure
Today, robots and unmanned aerial vehicles are being used extensively in modern societies. Due to a wide range of applications, it has attracted much attention among scientists over the past decades. This paper deals with the problem of the stability of a four-rotor flying robot called quadrotor, which is an under-actuated system, in the presence of operator or sensor failures. The dynamica...
متن کاملBackstepping based PID Control Strategy for an Underactuated Aerial Robot
In this paper a nonlinear model of an underactuated quad rotor aerial robot is derived, based on Newton-Euler formalism, and backstepping based PID control strategy is implemented for the derived model. Model derivation comprises determining equations of motion of the quad rotor in three dimensions and seeking to approximate actuation forces through modeling of aerodynamic coefficients and elec...
متن کاملThe HoverBot C An Electrically Powered Flying Robot
This paper describes the development of a fully autonomous or semi-autonomous hovering platform, capable of vertical lift-off and landing without a launcher, and capable of stationary hovering at one location. The idea to build such a model-sized aerial robot is not new; several other research institutes have been working on aerial robots based on commercially available, gasoline powered radio-...
متن کامل