Experimental Correlation betwee,n the Enduran’c’e of a $Wing Spar Joint and the Ratio between 0.1 per cent Proof and Ultimate Tensile Strengths of the Material
نویسنده
چکیده
منابع مشابه
Correlation between the Weld Residual Stresses and its Tensile and Impact Strength
In this study, the tensile strength, impact strength, and the hardness of the weld are determined. A criterion is proposed for describing the effect of residual stress on the weld mechanical properties. Dimensionless parameters such as Rya (the average of residual stress over the material yield strength), Rym (the maximum residual stress over the material yield strength), ...
متن کاملFlexural Behavior of Reinforced HPFRCC Beams
High Performance Fiber Reinforced Cementitious Composite (HPFRCC) materials exhibit strain hardening behavior with multiple cracking under tensile loading. In this paper, experimental and parametric studies are performed to assess the influence of using HPFRCC material instead of normal concrete in reinforced concrete beams. After calibrating the experimental results, the analytical results inc...
متن کاملEffects of Nanotube/Matrix Interface on Multi-Walled Carbon Nanotube Reinforced Polymer Mechanical Properties
In this paper, experimental and Finite Element Methods have been used to determine mechanical properties of nanocomposites. Standard tensile and compression samples with 0.0, 0.15, 0.25, 0.35, 0.45, and 0.55 weight fraction of Multi-Walled Carbon Nanotube (MWCNT) were prepared and tested. Nanotube weight fraction was varied to investigate the effects of nanotube weight fraction on nanocomposite...
متن کاملEffect of Activated Flux on Properties of SS 304 Using TIG Welding
In this experimental work, Manganese oxide (MnO2), Zinc oxide (ZnO), Iron oxide (Fe2O3) and Magnesium chloride (MgCl2) were used as activating flux to investigate the effects for SS 304 in tungsten inert gas (TIG) welding. Ultimate tensile strength, percentage elongation, Penetration depth and width were studied of material SS 304. The experimental results indicated that the MnO2 and Fe2O3 flux...
متن کاملFriction stir welding of accumulative roll bonded single phase brass
Single phase brass strips with 2 mm thickness were severely deformed through 1 and 3 cycles of accumulative roll bonding process (ARB). ARB process effectively increased the hardness, yield strength, and the ultimate strength of the processed materials. The hardness of processed material increased from 95 HV in annealed material to 225 HV in 3 cycle ARBed material, and the yielding and ultimate...
متن کامل