On the nature of different Fe sites in Fe-containing micro and mesoporous materials and their catalytic role in the abatement of nitrogen oxides from exhaust gases
نویسنده
چکیده
منابع مشابه
Modeling of Combustion and Carbon Oxides Formation in Direct Injection Diesel Engine
When looking at the effects of diesel engine exhaust on the environment, it is important to first look at the composition of the exhaust gases. Over 99.5% of the exhaust gases are a combination of nitrogen, oxygen, carbon dioxide, and water. With the exception of carbon dioxide, which contributes about 5% of the total volume, the diesel engine exhaust consists of elements which are part of...
متن کاملMethanol Steam Reforming Catalyzing over Cu/Zn/Fe Mixed Oxide Catalysts
Methanol steam reforming plays a pivotal role to produce hydrogen for fuel cell systems in a low temperature range. To accomplish higher methanol conversion and lower CO production, the reaction was catalyzed by CuZnFe mixed oxides. Various ratios of Fe and Cu/Zn were coprecipitated in differential method to optimize the CuZnFe structure. The sample containing 45Cu50Zn5Fe (Wt. %) revealed its m...
متن کاملCatalytic removal of nitrogen dioxide in the air stream by nickel and nickel- platinum supported multiwall carbon nanotube.
Introduction Nitrogen oxides as one of the most dangerous environmental pollutant, have harmful effects on the health of people in the workplace. Today, the catalytic oxidation of nitrogen oxides is a highly efficient method for removing of this gases that has been dedicated part of researches. The aim of study was to investigate the removal efficiency of nitrogen dioxide (NO2) by nickel and...
متن کاملریز بافت و کانیشناسی اکسیدهای Fe-Tiدر توده نفوذی مافیک- اولترامافیک قره آغاج، شمال باختری ارومیه
: Detailed studies on micro-texture and microprobe analysis of Fe-Ti oxides from Qareaghaj mafic-ultramafic intrusion (QMUI) is the basis of this investigation. The QMUI is mainly composed of non-mineralized mafic and Fe-Ti-P-rich ultramafic rocks (FTP). The FTP with high proportion of ilmenite (~11-19 modal %) and magnetite (~2-13 modal %) show an unusual bulk composition. Fe-Ti oxides are div...
متن کاملProduction of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying
In this research, the production of Fe-TiN and Fe-Ti(N,C) composite powders by mechanical alloying was investigated and evaluated. Ferrotitanium (containing 70%Ti), titanium and graphite were used as the raw materials. Initial mixtures were milled in different time durations under the pure nitrogen atmosphere with the pressure of 5atm. The results showed that when N2 pressure is 5 at...
متن کامل