Experimental investigation of added mass effects on a Francis turbine runner in still water

نویسندگان

  • C. G. Rodriguez
  • E. Egusquiza
  • F. Avellan
چکیده

The mechanical design of hydraulic turbines is conditioned by the dynamic response of the runner that is usually estimated by a computational model. Nevertheless, the runner has complex boundary conditions that are difficult to include in the computational model. One of these boundary conditions is the water in which the runner is submerged. The effect of the added mass and damping of water can modify considerably the natural frequencies of the runner. An experimental investigation in a reduced scale model of a turbine runner, using modal analysis, was carried out. Several impact tests with the runner freely suspended in air and in water were done. The response was measured with accelerometers located in different positions of the runner. From the modal analysis, the natural frequencies, damping ratios, and mode-shapes were determined. The same mode-shapes obtained in air were obtained in water but with lower natural frequencies and higher damping ratios in water. The difference in the natural frequencies is shown to be dependant basically on the added mass effect of the water and not on its added damping. This difference also depends on the geometry of the mode, presenting different values for different mode-shapes. Using nondimensional values, the reduction in the natural frequencies can be extrapolated to other Francis runners presenting similar geometrical characteristics. r 2006 Elsevier Ltd. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Fatigue Analysis of a Hydraulic Francis Turbine Runner

In this work, the estimation of crack initiation life of a hydraulic Francis turbine runner is presented. The life prediction is based on the local strain approach to predict the initiation life. First, the analysis is carried out in air and in water condition and the runner’s natural frequencies were calculated using the finite element (FE) method. The analysis in air is compared with experime...

متن کامل

Numerical simulation of fluid added mass effect on a francis turbine runner

In this paper, a numerical simulation to analyze the influence of the surrounding water in a turbine runner has been carried out using finite element method (FEM). First, the sensitivity of the FEM model on the element shape and mesh density has been analysed. Secondly, with the optimized FEM model, the modal behaviour with the runner vibrating in air and in water has been calculated. The added...

متن کامل

Numerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance

Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...

متن کامل

Added mass effects of attached cavitation on the blades of a Francis runner

Hydropower, a clean and renewable energy resource, has been developed worldwide for the economic development and improvement of people's living standards. It has also been used to improve the stability of the smart power grid. Depending on the water head of hydropower plants, various types of hydraulic turbines such as Francis, Kaplan and Pelton have been designed to maximize efficiency. Franci...

متن کامل

Modelling of the Francis turbine runner in power stations. Part II: stress analysis

The second part of this paper presents results of stress analysis of the whole Francis turbine runner at Derbendikan power station by using the Finite Element Method (FEM). Computations were carried out with appropriate boundary and loading conditions for water pressure obtained from CFD analysis. The analysis focuses on stress distribution in the runner blades. It has been found that the maxim...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006