Phase transformation of single crystal h-tungsten nanorods at elevated temperatures
نویسندگان
چکیده
We report the phase transformation of single crystal h-phase W(100) nanorods that occurs at an elevated temperature of ̈950 -C. The hW nanorods oriented perpendicular to the flat silicon substrate were grown by an oblique angle sputter deposition technique with substrate rotation. The nanorods typically have an average length of ̈450 nm and an average width of ̈75 nm. The phase transformation was investigated by X-ray diffraction measurements of the nanorods vacuum-annealed at various temperatures in the range 700–1000 -C for 30 min at each annealing temperature. As deposited individual nanorods are found to be single crystal, as evidenced from the analysis of transmission electron microscopy diffraction patterns. Our single crystal h-phase W(100) nanorods phase transformation temperature is higher than that of the polycrystalline simple-cubic h-phase (A15) W films. Depending on the deposition conditions, W films generally transform to thermodynamically stable bcc a-phase at temperatures ranging from room-temperature to ̈650 -C. The transformation is accompanied with the removal of oxygen atoms from the h-matrix. However, our results of W rods suggest that the removal of oxygen atoms from the single crystal W nanorods is more difficult due to the absence of grain boundaries that leads to the requirement of higher annealing temperatures for the phase transformation. D 2005 Elsevier B.V. All rights reserved.
منابع مشابه
Synthesis of CuO nanorods via thermal decomposition of copper-dipicolinic acid complex
Template-free CuO nanorods were synthesized through a three-step chemical method with no water-insoluble materials. The first step included the preparation of a Cu-complex, which was obtained from dipicolinic acid, L-lysine, and copper nitrate. Then, as the second step, the obtained solution was allowed to be relaxed for a week to and formation of some blue single-crystals single crystals, whic...
متن کاملEffects of Tungsten on the Pearlite Reaction in a Eutectoid Steel
The effect of an addition of 0.37 Wt % Won the overall transformation rate of the austenitepearlite reaction in a eutectoid steel is examined. Pearlite growth rates and interlamerllar spacing are measured as a function of transformation temperatures. Tungesten raises the Ael temperature, for most transformation temperatures, decreases the overall reaction rate, the growth rate and the interlame...
متن کاملFabrication and nanostructural characterization of TiO2 nanorods
TiO2 nanorods are synthesized by a thermal corrosion. In present work, synthesis of TiO2 nanorods in anatase, rutile and Ti8O15 phases, by using the sol-gel method and alkaline corrosion are reported. The morphologies and crystal structures of TiO2 nanorods are characterized by use of field emission scanning electron microscopy, atomic force microscopy and X-ray diffractometer techniques. The o...
متن کاملON THE FORMATION OF STRAY GRAINS IN DIRECTIONALLY-SOLIDIFIED NI-BASED SUPERALLOYS WITH VARYING CROSS SECTIONS
Formation of stray grain defects particularly around re-entrant features of the turbine blade airfoils is one of the major problems in directional and single crystal solidification processes. In this work, directional solidification tests of the GTD-111 Ni-based superalloy were conducted at different withdrawal velocities of 3, 6 and 9 mm.min-1 using various stepped cylindrical and cubic design...
متن کاملStructure and Properties of Wo3 Thin Films for Electrochromic Device Application
Among transition metal oxides, tungsten trioxide is one of the most interesting materials exhibiting a wide variety of novel properties particularly in thin film form useful for advanced technological applications. It exhibits structural transformations and substoichiometric phase transitions, which attracted the attention of researchers over the past few years to explore their potential scient...
متن کامل