Structure of molten Al and eutectic Al–Si alloy studied by neutron diffraction
نویسندگان
چکیده
منابع مشابه
EVALUATION OFDISLOCATION STRUCTURE AND CRYSTALLITE SIZE IN WORN AL-SI ALLOY BY X-RAY DIFFRACTION
Abstract: powerful method for the characterization of microstructures of crystalline materials in terms of crystallite size anddislocation structures. In this paper the effect of the sliding on the microstructure of A356 in the as-cast and heattreated conditions are studied, The X-ray phase analysis shows that with increasing applied load, the dislocationdensity is increased, whereas the crysta...
متن کاملStructure of Molten Sn-Zn-Alloys by Means of Neutron Diffraction
As a continuation of diffraction work on melts from eutectic binary systems such as Al-Sn [1], Au-Co [2], and Bi-Cu [3] an investigation of melts from the eutectic system Sn-Zn by means of neutron diffraction will be described in the present work. The liquidus lines in the constitution diagrams of these systems always show a point of inflection, so th a t segregation tendency in molten state is...
متن کاملTHE EFFECT OF CRYOLITE NA3ALF6 AND SODIUM FLUORIDE NAF ON THE CORROSION AND WETTING BY MOLTEN AL-SI ALLOY OF ANDALUSITE BASED REFRACTORIES
In order to improve the corrosion resistance of aluminosilicate refractories by molten aluminum, alkaline fluoride NaF and cryolite Na3AlF6 powders were studied. Both physical and chemical properties are known to influence wetting and corrosion behavior. This paper devoted to determine the influence of alkaline fluoride and cryolite added to andalusite based castable on the reaction with a...
متن کاملStructure of the Molten 37 a/o Cu-63 a/o Sb Alloy Using the Isotopic Substitution Method in Neutron Diffraction
A neutron diffraction study o f the eutectic Cu-Sb-melt containing 37 a/o Cu has been performed using isotopically enriched samples. The three partial structure factors describing the Cu-Cu, Cu-Sb, and Sb-Sb correlations have been determined as well as a second set of partial structure factors relating to the distance correlation o f fluctuations in number density and concentration. Unsmoothed ...
متن کاملEffect of Al–5Ti–C Master Alloy on the Microstructure and Mechanical Properties of Hypereutectic Al–20%Si Alloy
Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...
متن کامل