Blister patterns and energy minimization in compressed thin films on compliant substrates
نویسندگان
چکیده
This paper is motivated by the complex blister patterns sometimes seen in thin elastic films on thick, compliant substrates. These patterns are often induced by an elastic misfit which compresses the film. Blistering permits the film to expand locally, reducing the elastic energy of the system. It is therefore natural to ask: what is the minimum elastic energy achievable by blistering on a fixed area fraction of the substrate? This is a variational problem involving both the elastic deformation of the film and substrate and the geometry of the blistered region. It involves three small parameters: the nondimensionalized thickness of the film, the compliance ratio of the film/substrate pair and the mismatch strain. In formulating the problem, we use a small-slope (Föppl-von Kármán) approximation for the elastic energy of the film, and a local approximation for the elastic energy of the substrate. For a 1D version of the problem, we obtain “matching” upper and lower bounds on the minimum energy, in the sense that both bounds have the same scaling behavior with respect to the small parameters. The upper bound is straightforward and familiar: it is achieved by periodic blistering on a specific length scale. The lower bound is more subtle, since it must be proved without any assumption on the geometry of the blistered region. For a 2D version of the problem, our results are less complete. Our upper and lower bounds only “match” in their scaling with respect to the nondimensionalized thickness, not in the dependence on the compliance ratio and the mismatch strain. The lower bound is an easy consequence of our one-dimensional analysis. The upper bound considers a 2D lattice of blisters, and uses ideas from the literature on the folding or “crumpling” of a confined elastic sheet. Our main 2D result is that in a certain parameter regime, the elastic energy of this lattice is significantly lower than that of a few large blisters. c © 2000 Wiley Periodicals, Inc. Communications on Pure and Applied Mathematics, Vol. 000, 0001–0037 (2000) c © 2000 Wiley Periodicals, Inc. 2 JACOB BEDROSSIAN AND ROBERT V. KOHN
منابع مشابه
Influence of Co and Fe substitution on optical and structural properties of zinc oxide thin films
Zn0.97TM0.03O (TM = Co, Fe) thin films were deposited onto glass substrates by the sol–gel method and the effects of transition metals substitution on structural and optical properties of ZnO films were investigated. The X-ray diffraction patterns revealed that the films have wurtzite structure. Optical transmittance of the films was recorded in the range of 200 -800 nm wave length and the band...
متن کاملProtocol to perform pressurized blister tests on thin elastic films.
This work aims to identify common challenges in the preparation of the blister test devices designed for the measurement of the energy release rate for brittle thin films and to propose easy-to-implement solutions accordingly. To this end, we provide a step-by-step guide for fabricating a blister test device comprised of thin polystyrene films adhered to glass substrates. Thin films are first t...
متن کاملHerringbone Buckling Patterns of Compressed Thin Films on Compliant Substrates
A thin metal film vapor deposited on thick elastomer substrate develops an equi-biaxial compressive stress state when the system is cooled due to the large thermal expansion mismatch between the elastomer and the metal. At a critical stress, the film undergoes buckling into a family of modes with short wavelengths characteristic of a thin plate on a compliant elastic foundation. As the system i...
متن کاملThermal Oxidation Times Effect on Structural and Morphological Properties of Molybdenum Oxide Thin Films Grown on Quartz Substrates
Molybdenum oxide (α-MoO)thin films were prepared on quartz and silicon substrates by thermal oxidation of Mo thin films deposited using DC magnetron sputtering method. The influence of thermal oxidation times ranging from 60-240 min on the structural and morphological properties of the preparedfilms was investigated using X-ray diffraction, Atomic force microscopy and Fourier transform infrared...
متن کاملEnhanced Physical Properties Of Indium Tin Oxide Films Grown on Zinc Oxide-Coated Substrates
Structural, electrical and optical properties of indium tin oxide or ITO (In2O3:SnO2) thin films on different substrates are investigated. A 100-nm-thick pre-deposited zinc oxide (ZnO) buffer layer is utilized to simultaneously improve the electrical and optical properties of ITO films. High purity ZnO and ITO layers are deposited with a radio frequency sputtering in argon ambient with plasma p...
متن کامل