Thermal response of skin to cyclic pressure and pressure with shear: a technical note.

نویسنده

  • J E Sanders
چکیده

The thermal response of skin to pressure alone and to pressure with shear was compared under cyclic loading conditions. Stresses were applied to the anterior aspect of the leg of three healthy subjects for time intervals up to 10 min, and the difference in temperature between the stressed site and a contralateral control site was assessed after load release. The thermal recovery time (TRT), the time interval between load release and either a maximum or a stabilization in the temperature difference vs. time record was determined. Results demonstrated that for a resultant stress of 142.9 kPa, TRTs were longer for combined pressure and shear than for pressure alone. For Subjects A, B, and C, TRT increases were 1.5 min, 5.5 min, and 2.0 min respectively. For a resultant stress magnitude of 71.4 kPa, increases were 1.5 min, 3.5 min, and -0.5 min respectively. Comparing responses for different resultant stress magnitudes for pressure-only application, TRTs were 1.5 min, 1.5 min, and 5.5 min longer for the 142.9-kPa condition than for the 71.4-kPa condition for Subjects A, B, and C. For combined pressure and shear, increases were 1.5 min, 3.5 min, and 8.0 min respectively. A next step will be to determine if the TRT differences measured here are physiologically relevant and have clinical meaning. The thermal response assessment method could then potentially be used to quantitatively evaluate the effects of different interface design features in lower-limb prosthetics on tissue response.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and Analysis of Pressure Vessel Subjected to Pressure-temperature Variation (TECHNICAL NOTE)

Pressure vessel is a container used to store fluids under pressure and temperature. The fluids can be air, water, chemicals, fuel, gases etc. are most commonly used in food and chemical industries, oil refineries and so on. Pressure vessel is subjected to thermal and structural loads for power plant applications. Since the pressure vessel are subjected to both structural and thermal loads stres...

متن کامل

Effect of CO2 Partial Pressure on the Thermal Decomposition Kinetics of Zinc Carbonate Hydroxide (TECHNICAL NOTE)

In this work, the effect of carbon dioxide partial pressure on the calcination kinetics of high purity zinc carbonate hydroxide has been studied. Non-isothermal analysis has been performed on samples at different CO2 partial pressures by TGA and DTA. It has been found that the calcination behaviour of this material corresponds to the shrinking core model and the reaction mechanism is phase boun...

متن کامل

Deformational Characteristics of Rocks Containing a Single Discontinuity (TECHNICAL NOTE)

For the purpose of exploring deformation characteristics of jointed rock masses, influence of joint inclination and confining pressure on the mechanical behavior of discontinuous rock a series of compression tests were conducted under satisfactory testing conditions on three types of sandstone from various locations. Three groups of jointed specimens were used in this research, including specim...

متن کامل

Multi-objective Optimization of Stirling Heat Engine Using Gray Wolf Optimization Algorithm (TECHNICAL NOTE)

The use of meta-heuristic optimization methods have become quite generic in the past two decades. This paper provides a theoretical investigation to find optimum design parameters of the Stirling heat engines using a recently presented nature-inspired method namely the gray wolf optimization (GWO). This algorithm is utilized for the maximization of the output power/thermal efficiency as well as...

متن کامل

Transient Two-Dimensional (r-z) Cyclic Charging/Discharging Analysis of Space Thermal Energy Storage Systems (RESEARCH NOTE)

A two-dimensional transient axi-symmetric model was developed to study the effects of various thermal and geometric parameters on cyclic heating and cooling modes of a phase-change thermal energy storage system. The high-temperature thermal energy storage device utilizes LiH for heat sink applications to store the waste heat generated during power-burst periods. The stored heat is then discharg...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of rehabilitation research and development

دوره 37 5  شماره 

صفحات  -

تاریخ انتشار 2000